Argos 392/ 2068 User manual

392/ 2068
BASIC RANGE FLOOR CABINET DOOR
Width - 30cm
Depth - 28cm
Height - 120cm
Issue 1- 30/03/15

Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Check you have all the
components and tools listed on
pages 2 and 3..
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
•Assemble the item as close
room) as possible.
•Assemble on a soft level
surface to avoid damaging the
• Parts of the assembly will be
easier with 2 people.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
•This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
•Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
tightend properly.
Handy Hints
• We do not
recommend the use
of power drill/drivers
for inserting screws,
as this could damage
the using. Only use hand
screwdrivers

1Top panel x 1
(30(w)cm x 28(d)cm)
5Cross bar x 1Shelf panel x 2
(27(w)cm x 4(d)cm)
9Drawer right side panel x 1
(26(w)cm x 20(d)cm)
13 Apron x 1
(27(w)cm x 4(d)cm)
14 Back panel x 1
(116(w)cm x 29.8(d)cm)
10 Drawer Back panel x 1
(24(w)cm x20(d)cm)
11 Drawer bottom panel x 1
(25.6(w)cm x 24.8(d)cm)
12 Shelf panel x 1
(26(w)cm x 26.5(d)cm)
6Door panel x 1
(54w)cm x 26.5(d)cm)
7 Drawer front panel x 1
(27.5(d)cm x 26.5(w)cm)
8 Drawer left side panel x 1
(26(w)cm x 20(d)cm)
2Left side panel x 1
(118.7(w)cm x 28(d)cm)
3Right side panel x 1
(118.7(w)cm x 28(d)cm)
4
(26.9(w)cm x 27.9(d)cm)

35mm Male camlock x 16
30mm Screw x 4
250mm Drawer rail x 2
10mm Screw x 4 20mm Sticker x 4
16mm Bolt x 2 Drawer limiter x 2
35mm Screw x 1
Shelf bracket x 4
Washer x 2 Wall anchor x 1
12mm Screw x 1
12mm Screw x 18
Knob x 2
Hinge x 2
12mm Screw x 10
15mm Female camlock x 12
12mm Female camlock x 4
30mm Wooden dowel x 8
N
P
T U V W
Q R
14mm Screw x 2
S
Safety strap x 1
O

Connect the male
camlock as directed in
the assembly instructions
using a screwdriver.
Push the male camlock
into the entry hole.
lnsert the female
camlock as shown in the
instructions
Note: ensure that the
Turn the female camlock
clockwise with a
arrow on the top of the
camlock points towards
the entry hole for the
male camlock.
screwdriver.
You should feel a click
when the camlock is
locked in place.
The joint is now secure.
Using Camlocks

S
L
5
A
A
1
7
Insert 8 x male camlock
into inside of left side
panel and right side
panel as shown.
Fix 2 x drawer rail to
inside of left side
panel and right side
panel using 4 x screw
as shown.
V
U
A
2
3
2
3
Fix 1 x magnetic catch
to underside of cross
bar using 2 x 14mm
screw as shown.
L
S
5
Insert 8 x male camlock
into underside of top
panel and drawer front
panel as shown.
A
1
7
A
A
U
U
V
V
3
2

B
5
6
Insert 2 x 30mm wooden
dowel into right end of
cross bar and attach
it to right side panel
as shown.
Insert 2 x 30mm wooden
dowel into right end of
apron and attach it to
right side panel as
shown.
Attach 2 x shelf panel
to right side panel
using 4 x 15mm female
camlock as shown.
Tighten female camlocks
with a screwdriver.
Please refer to the “Using
Camlocks” section at the
front of this instruction for
further assistance.
C
B
C
4
3
3
3
13
Insert 4 x 30mm wooden
dowel into right end of
cross bar and apron
as shown.
Attach left side panel
to assembled part using
4 x 15mm female camlock
as shown.
Tighten female camlocks
with a screwdriver.
C
2
3
13
Attach top panel to
assembled part using
4 x 15mm female camlock
as shown.
Tighten female camlocks
with a screwdriver.
1
5
B
B
B
B
C
C
4
4
3
13
5
C
B
B
2
B
1

8
7
7
10
11
F
F
E
J
I
9
Attach back panel to
7
8
assembled part using
18 x 12mm screw as
shown.
14
H
4 x 30mm screw as
F
Attach drawer left side
panel and drawer right
side panel to drawer
back panel using
shown.
Insert drawer bottom panel
into the grooves of
drawer left side panel
and drawer right side
panel , and slide it into
the groove of the drawer
back panel as shown.
Attach the drawer front
panel to the assembled
part of drawer using
4 x 12mm female camlock
as shown.
Tighten female camlocks
with a screwdriver.
Attach 1 x knob to the
drawer front panel using
1 x bolt as shown.
8
9
10
E
I
J
8
9
7
7
10
11
14
H

Insert the assembled
9
drawer into the chest
and make sure 2 x drawer
rail inserted into the
grooves of the drawer
side panel and ,
then insert 2 x drawer
limiter into the holes
of the drawer side panel
and as shown.
Insert 4 x shelf bracket
into inside of the left side
panel and the right
side panel , then put
shelf panel on them
as shown.
Gently tighten the upper
4 x female camlocks and
paste 4 x 20mm sticker
over the holes of them
as shown.
12
8 9
89
3
2
U
T
K
W
T
K
W
12

Fix unit to wall using 1 x
10
12mm screw , 1 x
safety strap , 2 x
washer , 1 x 35mm
screw and 1 x wall plug
as shown.
6
6
6
3
N
O
P
Q
R
M
I
J
G
D
G
Fix 1 x magnetic catch
plate to the door panel
using 2 x 12mm screw
as shown.
Fix 1 x knob to the door
panel using 1 x bolt
as shown.
Attach the door panel
to the right side panel
using 2 x hinge and
8 x 12mm screw as
shown.
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 640 0800
Argos LTD. 489-499 Avebury boulevard, Central Milton Keynes, MK9 2NW
J
I
G
M
D
G
N
Q
O
P Q O R
6