Argos 9011179 User manual

Coat & Umbrella Stand
Dimensions
Width - 33cm
Depth - 33cm
Height - 179.5cm
Important – Please read these instructions fully before starting assembly
Assembly Instructions- please keep for future reference
Issue 2 - 04/01/12
LP 307.95.501
If you need help or have damaged or missing parts, call the Customer Helpline: 0121 753 7720
Assembly Instructions
Step 1
Assemble the parts in
the following order, from
the bottom up:
Large hex bolt A
through 1 x washer B,
through base weight 1,
through base 2,
through 1 x washer B,
through umbrella cup 3,
screwed into bottom
pole 4.
Double ended bolt C
(bottom end), through
1 x washer B, through
1 x cup washer D, then
screwed into top of
bottom pole 4.
Double ended bolt
C (top end),
through
umbrella rack
5
,
through 1 x washer B,
through 1 x cup washer
D, screwed into bottom
of middle pole 6.
1 x connector E
screwed into top of
middle pole 6.
Top pole 7 screwed
onto top of connector E.
Step 2
Connect each hook 8
to top of top pole 7
using 2 x small hex bolt
F. Tighten with the allen
key.
Insert large end stop G
into top of pole and 1 x
small end stop H into
bottom end of hooks 8.
Push 1 x knob 9 onto
top of each hook 8.
Assembly complete.
A
B
B
B
D
E
H
F
G
C
B
D
1
3
4
6
7
8
9
5
2
If you need help or have damaged or missing parts, call the Customer Helpline: 0121 753 7720

Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Care and maintenance
• Check you have all the
components and tools listed
opposite.
• Remove all ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close
to its nal position (in the same
room) as possible.
• Assemble on the oor only as
the weighted base is very heavy.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use the allen key provided.
• Dispose of all packaging
carefully and responsibly.
• Only clean using a damp
cloth and mild detergent, do
not use bleach or abrasive
cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre.
Components - Panels
Please check you have all the panels listed below
1 Base weight x 1
(33(dia)cm)
2 Base x 1
(33.5(d)cm)
3 Umbrella cup x 1
(16(dia)cm)
4 Bottom pole x 1
(46(h)cm)
5 Umbrella rack x 1
(30(dia)cm)
6 Middle pole x 1
(55(h)cm)
7 Top pole x 1
(55(h)cm)
8 Coat hook x 5 9 Knob x 5
Components - Fittings If you have damaged or missing components,
call the Customer Helpline: 0121 753 7720
Please check you have all the ttings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more ttings
may be supplied than are required.
A B C
Large hex bolt x 1 Washer x 4 Double ended bolt x 1
D E F G
Cup washer x 2 Pole connector x 1 Small hex bolt x 10 Large end stop x 1
H I
Small end stop x 5 Allen key x 1