Argos ColourMatch Gas Lift Bar Stool 600/6060 User manual

ColourMatch Gas Lift Bar Stool
Assembly Instructions - Please keep for future reference
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800
Issue 1 - 28/04/14
Dimensions
Width - 38.5cm
Depth - 40cm
Height - 64-86cm
600/6015
600/6060
600/6008
600/5982
600/5975
600/5999
239/1085
242/9380
259/5647

1
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Parts of the assembly will be
easier with 2 people.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Do not stand on the stool.
• Do not use this stool as step
ladder.
• To reduce the
likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Unit weight: 5.5 kgs.
• Maximum safe weight of user:
110kgs.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
Handy Hints
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.

2
Components - Parts
Please check you have all the parts listed below
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 640 0800
1Seat
(38.5 x 37 x 46cm)
2Gaslift
(Ø5 x 49-71cm)
3Decor ring
(Ø5 x 7.5 x 2cm)
4Base
(Ø38.5 x 8.5cm)

3
Step 3
Attaching the seat
Insert the gaslift into
the seat . Secure by
pressing down the seat
firmly.
Gaslift operation
Assembly is complete.
To adjust the seat higher,
lift up the lever under the
seat and release at
desired height.
To lower the seat, lift up
the lever while fully
seated on the stool.
To ensure proper operation
of the gaslift, a person
must sit fully on the seat.
Sitting on the tip or edges
of the seat may not
activate the gaslift properly.
1
2
Assembly Instructions
Step 1
Step 2
Attaching gaslift
Place the base on a
flat protected surface.
Position the decor ring
on the base and insert
the gaslift into the
decor ring and hole of
the base.
Important:
Remove plastic tip
cover on
gaslift before
assembling.
4
3
2
Lever
2
1
4
3
2
Please remove
Plastic tip
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800