Argos 609/1006 User manual

Small Extra Deep Bookcase
Assembly Instructions -
Please keep for future reference 609/1006
Dimensions
Depth - 29.1cm
Width - 78cm
Height - 91.5cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Ref. no. 609/1006,609/2067,609/2782,610/9565,610/9479,610/9493,610/9486 Date: 20/11/09
609/2067
609/2782
610/9565
610/9479
610/9493
610/9486

1
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
Safety and Care Advice
Important– Please read these instructions fullybefore starting assembly
components and tools listed on
pages 2 and 3.
plastic bags and separate them
into their groups.
away from the work area, small
parts could choke if swallowed.
space to layout the parts before
starting.
this could cause damage.
room) as possible.
surface to avoid damaging the
easier with 2 people.
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
carefully and responsibly.
and mild detergent, do no use
bleach or abrasive cleaners.
there are no loose screws on
this unit.
discarded with household
waste. Take to your local
authority waste disposal centre.
Care and maintenance
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
Glue safety - Take care when using glue, please follow the advice below
Note:
Only apply the glue
once you are sure of the
assembly.
Do not stand on the product,

2
Components - Panels
Please check you have all the panels listed below
Top Panel (749 x 285mm)
1
Bottom Panel (749 x 285mm)
2
Front Panel (749 x 59mm)
3
Left Side Panel (915 x 286mm)
6
Shelf x 2 (749 x 284mm)
4Back Panel (850 x 767mm)
7
Right Side Panel (915 x 286mm)
5

3
Note: The quantities below are the correct amount to complete the assembly. in some cases more ttings
may be supplied than are required.
Components - Fittings
Please check you have all the ttings listed below
110 120 130 140 1500 10 20 30 40 50 60 70 80 90 100
0 1 2 3 4 5 6
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
Tools required
Phillips screwdriver
(medium & large)
Bradawl
(or sharp point)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
Ruler - Use this ruler to help correctly identify the screws
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
ABC
DEF
GHI
JKL
14mm Screw x 9
Shelf Support x 8
M
Wooden Dowel x 4
50mm Screw x 8
30mm Screw x 1
Q
Wall Strap x 1
Nail x 20
Glue x 1
Nail Guide x 1
Support Cover x 8
Wall Plug x 1
Covering Sticker x 8
Plastic Support x 4

4
Assembly Instructions
Step 1
a:
Step 2 a:
a:
Step 3
Fixing back panel
Use Nails to x the
Back Panel onto the
unit.
Note: Use Nail Guide to
keep a constant distance
from the edge.
J
K
a:
7
A
A
A
A
B
B
B
B
B
B
B
B
3
Unnished
back edge
7
D
D
D
D
D
D
D
D
Attaching side panels
D
E
I
K
J
2
Attaching bottom panel
a:
Use Plastic Supports
and Screws to x the
Front Panel onto the
Bottom Panel .
A
2
3
B
2
1
5
6
E
E
E
E
a:
Place a small amount
of Glue into the dowel
holes and onto the join’t
sufaces.Use Screws and
Wooden Dowels to x
the Left Side Panel and
Right Side Panel onto
the Bottom Panel and
Top Panel .
I
6
5
2
1
The cabinet MUST
be ‘square’ when
the back is attached.
E
Important:
Finished
front edge

Step 4
Assembly Instructions
b:
Slide the Shelves
into the unit.
4
b:
4
a:
5
GF
4
G+F
Attaching shelf panel
a:
SIide Support Covers
onto Shelf Supports .
lnsert Shelf Supports
(Support Covers are
included) into the unit.
Ensure they are well tted
before inserting the Shelves.
GF
F
Note:
Set the shelf
supports to the desired
height.
G
H
H
H
H
H
H
H
H
Use Covering Sticker to
cover the Screw Heads.
H

Step 5
Assembly Instructions
If you need help or have damaged or missing parts, call the
Customer Helpline: 08456 400800
The assembly is now
complete.
Note:
be used for your wall, seek
professional advice if in doubt.
It is recommended that the
bookcase is xed to a
wall.
Strap onto the back of
the top panel.
With help, move bookcase
into position.
remove bookcase .
Drill a hole and insert Wall
Plug .
Reposioion bookcase
Screw .
Fixing to wall
Warning:
The bookcase is
heavy.
Lift with care.
Warning:
Before drilling,
check wall for
hidden pipes and
and cables.
B
L
6
wall
B
L
Top Panel
M
C
M
C
Note: Before use allow
the Glue to dry for 24
hours and make sure
the unit is secure.

A Guide to - Wall Mounting & Fixings
Revision 2 - 7/10/09
Important note:
Types of walls
Care &
Maintenance
No.1 “General Purpose” wall plug
No.6 “Shield Anchor” wall plug
Heavy loads
No.3 “Cavity Fixing” wall plug
No.4 “Cavity Fixing-Heavy Duty”
wall plug
No.5 “Hammer Fixing” wall plug
No.2 “Plasterboard” wall plug
Generally aerated blocks should not
be used to support heavy loads, use
a specialist tting in this case. For light
loads, general purpose wall plugs can
be used.
For use with heavier loads such as TV
& HiFi speakers and satelite dishes etc.
For use with plasterboard partitions or
hollow wooden doors.
For use when tting or supporting
heavy loads such as shelving, wall
cabinets and coat racks.
For use with walls stuck with
plasterboard. The hammer xing allows
it to be xed to the wall rather than the
plasterboard. Always check the xing
is secure to the retaining wall.
For use when attaching light loads on
to plasterboard partitions.
Safety: Always check the fitting
and location to ensure your safety
in and around the home.
Fitting: From time to time check
the fitting to ensure the wall plugs
or screws do not become loose.
You can use one of the following types of wall plug if your walls are made
of brick, breeze block, concrete, stone or wood.
Important: When drilling into walls always
check that there are no hidden wires or pipes etc.
Hints:
1: General rule: Always use a larger screw and wall plug
if you are not sure.
2: Ensure you use the recommended drill bit to match the wall
plug and hole size.
3: Ensure you drill the hole horizontally, do not force the drill or
enlarge the hole.
4: Take extra care when drilling high walls, ceilings and ceramic
tiles. Ensure wall plugs are inserted beyond the thickness of
the ceramic tiles to avoid the tiles splitting or cracking.
5: Ensure wall plugs are well tted and are a tight t in the
drilled hole.
If plastic wall plugs
are supplied with your
product:
Make sure that the screws and wall plugs being used
are suitable for supporting your unit. Consult a qualified
tradesperson if you are unsure.
- these are only suitable for
use in masonry walls.
If you are in any doubt about
the correct wall plugs for
your wall, seek professional
advice.
Failure of the product due to
using incorrect xings is the
responsibility of the installer.

Small Extra Deep Bookcase
  











Important 
Version 3 Date: 24/09/14
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800


Safety and Care Advice
Important – Please read these instructions fully before starting assembly
components and tools listed on
the following pages.
ttings from the
plastic bags and separate them
into their groups.
space to layout the parts before
starting.
do not stand
this could cause damage.
Assemble the item as close
to its nal position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your oor.
easier with 2 people.
To reduce
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
bleach or abrasive cleaners.
m
there are no loose screws on
this unit.
This product should not be
discarded with household waste.
Ta
waste disposal centre.
Care and maintenance
Assemble all parts and bolts
loosely during assembly
once the product is complete
should you fully tighten the bolts
c
that all bolts and ttings are
tightend properly.
Handy Hints