Argos 875/7276 User manual

Issue date: 27/03/2007
Revision number: 3
ARGOS Ltd.
KD Sea Grass Chest 875/7276 (D)
Easy Assembly Instructions
Introduction
Tools required:
Allen Key –
Supplied.
Care & Use.
•Dust with a clean cloth / duster.
•Do not use water.
•Do not allow to become damp.
Note: Do not tighten any of the screws until all parts are together.

Issue date: 27/03/2007
Revision number: 3
Components / fixings list
Components Fixings
Screws x 16
Hinge rods x 4
Allen key - supplied
Hooks x 2
A – Rear Panel
B – Front Panel
C – Base board
D – Lid
E – Left hand side
F – Right hand side
E
B
F
C
D
A

Issue date: 27/03/2007
Revision number: 3
ASSEMBLY – STAGE ONE
Front / Base / Sides assembly.
1. Attach part ‘A’ Back Panel
to part ‘C’ Base using 3
screws.
The screws should only be
screwed in 2 or 3 turns until
ALL panels are in place. Then
fully tighten all the screws.
Note: Poke the sea grass to
find the screw hole. The
screws go through these
holes to secure the panels.
See drawing opposite.
2. Attach parts ‘E’ & ‘F’ Side
Panels to Base / Rear panel
assembly using 6 screws.
Ensure that the handles are
on the outsides, & that the lid
securing chain fixings are
near the back panel.

Issue date: 27/03/2007
Revision number: 3
ASSEMBLY – STAGE TWO
Front / Lid assembly
3. Attach part ‘B’ Front panel
to Sides & Base, using 7
screws.
Finally fully tighten all
screws.
4. Attach Lid ‘D’ to chest
assembly, by locating the
hinge flaps together & then
securing by pushing the
‘Rods’ in from both sides of
the hinge.

Issue date: 27/03/2007
Revision number: 3
ASSEMBLY – STAGE THREE
Final lid assembly
5. Attach the chain on the lid
& on the rear inside face of
each side to the hook as
shown.