Argos HOME 607/7446 User manual

HM 6 TIER EXTENDABLE SHOE RACK CHROME
607/7446
Assembly Instructions - Please keep for future reference
Dimensions
Width - 62.5-118.5cm
Depth - 22.5cm
Height - 78-100cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800
Issue 1 - 10/11/16

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightened properly.
Handy Hints
Note: If required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.

Components - Parts
Please check you have all the fittings listed below
Screw x 24
A
2
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
If you have damaged or missing components,
call the Customer Helpline: 03456 400800
Steel Tube x 12
1Side Frame x 2
2
Rubber End Cap x 8
B
Tools required
Screwdriver

Assembly Instructions
Step 1
Step 2
Assemble the Unit
1. Connect Steel Tube
with Side Frame
together using Screw .
2. Insert End Cap to
Top and Bottom Side
Frame .
The unit is complete
Important Note:
The maximun load for
each tier is 4 kg.
Please do not put any
heavier object than 4 kg
on each tier.
3
fig. 2
fig. 1
A
B
1
2
2
see fig.1
see fig.2
1
A
B
B
2