Argos Phoenix 162/2690 User manual

Dimensions
Width - 70cm
Depth - 35.5cm
Height - 70cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Version2 Date: 23/10/13
166/6632
181/5971
Phoenix 2 Half Door Storage Cubes
Assembly Instructions -
Please keep for future reference 162/2690
166/6230

• Argos Ltd. MK9 2 NW. • This product is suitable for
children in the age 6 or above.
• Maximum load: 20 kgs.
• Regularly check all fastenings
to ensure that they are properly
tightened.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
pages 2 and 3.
rom the
plastic bags and separate them
into their groups.
• Keep children and animals away
from the work area, small parts
could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand on the product,
this could cause damage.
• Assemble the item as close to
room) as possible.
• Assemble on a soft level surface
to avoid damaging the unit or your
r.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Do not use this item if any
components are missing or
damaged.
• Assembly to be carried out by
the competent adult only.
• During assembly children should
be kept away from the product due
to the potential risk of injury.
1
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.

2
Please check you have all the panels listed below
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
Components - Panels
Middle support x 2
(34.9 x 32.6cm)
4
Back panel x 2
(34.5 x 69.5cm)
5
Door panel x 2
(32 x 32cm)
6
Top/Bottom panel x 2
(69.9 x 34.9cm)
1
Side panel x 2
(66.8 x 34.9cm)
2
Shelf (66.8 x 34.9cm)
3
Pilot holes for
guidance only
Pilot holes for
guidance only

3
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
Components - Fittings
110 120 130 140 1500 10 20 30 40 50 60 70 80 90 100
0 1 2 3 4 5 6
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
Tools required
Phillips screwdriver
(medium & large)
Bradawl
(or sharp point)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
Ruler - Use this ruler to help correctly identify the screws
B
30mm Dowel x 12
E
12mm Screw x 6
A
50mm Dowel x 2
C
50mm Screw x 8
H
Door Stopper x 2
F
Nail x 22
G
Screw cover x 4
J
Door hinge x 4
I
Handle x 2
K
Metal plate x 2
L
33mm Screw x 1
D
25mm Screw x 2
Wall strap x 2
M
Wall plug x 1
N
14mm Screw x 3
O
Note M O : Please keep the

Assembly Instructions
Step 1
Attaching door
stoppers
Step 2
Attaching metal plates
& door hinges
4
Metal plates onto the
Door panels .
Insert the Door hinges
into the Door panels .
E
6
K
J
6
Door stoppers onto the
Middle supports .
E
H
4
E
E
H
J
E
K
E
E
H
4
X 2
X 2
J
J
E
K
6

Assembly Instructions
Step 3
5
b:
2
b: Fix the
3
p
onto the Shelf .
3
2
2
Finished
front edge
a:
4
4
3
Finished
front edge
Finished
front edge
A
A
B
B
B
B
B
B
B
B
B
B
Attaching the side
panels
a:
supports onto
the Shelf .
4
3
4
3
A
Insert Dowels into
the
Shelf and Middle
B
supports .
Middle

Assembly Instructions
Step 4
Note:
Carefully locate the Door
panel onto the unit,
aligning the Door hinges
with the corresponding
holes.
Top panel onto the unit.
6
1
Ensure the Door
hinges are aligned with
the corresponding holes.
C
6
b:
b:
a:
Carefully locate the Door
panel onto the unit,
aligning the Door hinges
with the corresponding
holes.
Bottom panel onto the
unit.
6
1
Note: Ensure the Door
hinges are aligned with
the corresponding holes.
C
Attaching the door
panels
a:
1
6
6
1
C
C
C
C
C
C
C
C
Finished
front edge
Finished
front edge

I
I
D
D
7
Assembly Instructions
Step 5
Step 6
Attaching the handles
Handles onto the Door
panels .
D
I
6
I
D
66
5
12
5
Fixing back panel
Back panels onto the
unit.
F
5
F
back surface
back edge
Important:
The unit MUST
be ‘square’ when
the back is attached.

Step
Assembly Instructions
Finishing the unit
With help, place the unit in
the intended position.
Step 8
Use Screw c overs to
cover the screw heads.
G
Attaching the screw
covers
7
G
G
G
G
Assembly is complete.
8

Assembly Instructions
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Fixing with another unit
With help, move the unit
remove the unit.
Drill a hole and insert Wall
plug .
Reposition
Fixing to wall
Warning:
The unit is heavy.
Lift with care.
Warning:
Before drilling,
check wall for
hidden pipes
and cables.
N
L
O
M
It is recommended that the
Wall strap to link
another unit from the
back.
into position.
strap using Screw .
strap onto the top panel.
O
M
U
S
9
X 2
Step 9
O
M
O
a: b:
a:
b:
wall
O
M
Top panel
N
L
LMN
Note: Wall plugs supplied are
for solid wall only.
be used for your wall, seek
professional advice if in doubt

A Guide to - Wall Mounting & Fixings
Revision 2 - 7/10/09
Important note:
Types of walls
Care &
Maintenance
No.1 “General Purpose” wall plug
No.6 “Shield Anchor” wall plug
Heavy loads
No.3 “Cavity Fixing” wall plug
No.4 “Cavity Fixing-Heavy Duty”
wall plug
No.5 “Hammer Fixing” wall plug
No.2 “Plasterboard” wall plug
Generally aerated blocks should not
be used to support heavy loads, use
loads, general purpose wall plugs can
be used.
For use with heavier loads such as TV
& HiFi speakers and satelite dishes etc.
For use with plasterboard partitions or
hollow wooden doors.
heavy loads such as shelving, wall
cabinets and coat racks.
For use with walls stuck with
is secure to the retaining wall.
For use when attaching light loads on
to plasterboard partitions.
Safety: Always check the fitting
and location to ensure your safety
in and around the home.
Fitting: From time to time check
the fitting to ensure the wall plugs
or screws do not become loose.
You can use one of the following types of wall plug if your walls are made
of brick, breeze block, concrete, stone or wood.
Important: When drilling into walls always
check that there are no hidden wires or pipes etc.
Hints:
1: General rule: Always use a larger screw and wall plug
if you are not sure.
2: Ensure you use the recommended drill bit to match the wall
plug and hole size.
3: Ensure you drill the hole horizontally, do not force the drill or
enlarge the hole.
4: Take extra care when drilling high walls, ceilings and ceramic
tiles. Ensure wall plugs are inserted beyond the thickness of
the ceramic tiles to avoid the tiles splitting or cracking.
5:
drilled hole.
If plastic wall plugs
are supplied with your
product:
Make sure that the screws and wall plugs being used
are suitable for supporting your unit. Consult a qualified
tradesperson if you are unsure.
- these are only suitable for
use in masonry walls.
If you are in any doubt about
the correct wall plugs for
your wall, seek professional
advice.
Failure of the product due to
responsibility of the installer.