Assa Abloy Lockwood Optimum User manual

Installation Instructions
Application: Provides secure deadlocking for aluminium hinged
doors. Palladium Xtra furniture available with daylatch snib and
LockAlert features.
OptimumTM Mortice Lock
Pack Contents:
Cylinder Key & Turn Knob
Cylinder Double Key
Latch wear pad
Interior Furniture
(Aria Furniture shown)
Exterior Furniture
(Aria Furniture shown)
2-Point Lock
or
92mm Drive
Bar (Spindle)
Palladium and Verona Furniture, 2-Point
Tools Required: • Drill
• 3.2mm Drill Bit
• 10.0mm Drill Bit
• 20.0mm Drill Bit
• Phillips Screwdriver #2
• Square Screwdriver #1
8g x 7.5 Screws
M4 Furniture fixing screws
M5 Cylinder fixing screw
Screw Selection:
Screw Stile Width
M4 x 49mm 38 - 43mm
M4 x 55mm 43 - 49mm
M4 x 60mm 46 - 55mm
M4 x 65mm 55 - 58mm
2mm Latch Packer

1. Door Preparation
Route the door as shown in the routing diagram.
Note: For Palladium Xtra Furniture, see separate instructions.

2.Fixing Lock
• Place the lock assembly into the stile
• Fix the lock onto the stile using the two 8g x 7.5
screws
3. Fixing Furniture and Cylinder
• Insert the drive bar (spindle) through the square drive hole in the lock
• Place the furniture onto the drive bar. For security, ensure the interior handle is on the inside of the house
• Place the cylinder through the cylinder hole
• Fix cylinder using the M5 cylinder fixing screw as supplied
• Fix together the furniture using the two M4 furniture fixing screws. See screw selection chart to determine correct screw length
Note: If fixing Palladium Xtra Furniture with daylatch snib and LockAlert, refer to separate Palladium Xtra Furniture instructions enclosed.

Patent: NZ 556113
077188 Sept12
6. Latch Reversal
• Turn key to lock latch
• Undo the M4 latch screw
• Reverse the latch as desired
• Refasten the M4 latch screw to secure the latch
• Insert the latch wear pad
Note: 2mm Latch Packer is provided to allow for latch
projection adjustment. An additional 2mm packer is
available for purchase.
LOCKWOOD GUARANTEE
M4 Latch Screw
Latch Wear Pad
Latch
2mm Latch
Packer
7. Lock operation
Deadlocking Operation
• Pull the door shut. The door will self-latch
• Turn the key towards the edge of the door to deadlock
• The door is now secure from exterior and interior
Opening Operation
• Turn the key away from the door edge to deactivate the deadlock
• Push the handle down to retract the latch
Deadbolt
Latch Handle
Troubleshooting
Do I need to tap holes? No. All screws are self tapping.
The furniture screws do not
tighten
Ensure the screws line up with the screw
boss on the exterior handle.
Do I have to use the supplied
screws?
For best performance, it is recommended
that only the supplied screws are used.
The key function does not
operate
Ensure the motion of the latch is not
restricted.
Turn key
to throw
deadbolt
ASSA ABLOY New Zealand Limited
6 Armstrong Road, Albany, Auckland 0632
[e-mail]
www.assaabloy.co.nz
ASSA ABLOY Australia Pty Limited
235 Huntingdale Road, Oakleigh, Vic 3166
[e-mail]
www.assaabloy.com.au