Assa Abloy LOCKWOOD Sliding Door Latch User manual

Installation Instructions
Tools Required: • Drill • 10.0mm Drill Bit
• 3.0mm Drill Bit • Phillips Screwdriver
Door Specifications: ø10mm
ø10mm
ø10mm
20mm 20mm
Centre line of fixing
screw holes
1. Fixing Holes Required in Frame
Refer to door specification drawing to determine hole
centres. Drill three holes into the door frame ø10mm, the top
and bottom holes spaced 20mm from centre hole and inline
vertically. Remove any burs from the edge of the holes.
Note: The centre fixing hole should be at least 1.5m from the
floor to comply with swimming pool fencing regulations.
Ensure beak
points down
3. Assemble Latch
Insert the latch to the inside chassis assembly.
Snib tabs away
from door frame
Snib tabs away
from door frame
2. Fitting Chassis Assemblies to Frame
Align chassis assemblies to either side of doorframe. Screw the chassis to the door frame
(do not tighten at this stage) using the 2 x M4 fixing screws provided. Ensure the snib lever is
facing away from the door jamb.
Application: Self latches sliding door on closure.
Pack Contents:
2 x Chassis
Assemblies
Inside Cover Outside Cover
Strike Cover Screw PackStrike Latch
Drive Bar
Sliding Door Latch

Patent: NZ 556113
6g x
12.5mm
screws
6g x
14.5mm
screws
6. Fixing Strike to the Door Jamb
The strike can either be face fixed or side fixed (depending
on the design of the frame profile). Mark the hole positions
as close as possible in the centre of the fixing hole slots in the
strike. Drill two ø3mm holes for the 6g screws provided. Fix
the strike to the door frame.
7. Check Function
The latch should engage in
the strike automatically when
the door is closed and not
release unless the snib lever is
rotated down (either on the
inside or outside of the door).
8. Fit Covers
Clip the inside and
outside covers to the
chassis assemblies. Note
that both covers have cut
outs for the snibs but the
inside cover only has a cut
out for the latch. Fit the
strike cover to the strike.
9. Installation
Complete
4. Assemble Drive Bar
and Check Function
Insert the driving bar
between the two chassis
assemblies. Tighten the
M4 fixing screws fixing the
chassis assemblies, check
that the Sliding Door
Latch functions correctly.
Do not over tighten
screws.
5. Positioning Strike
Position the strike on the
frame by closing the door
and positioning the strike
vertically so it fully engages
with the latch.
Sliding Door Latch
077186 Feb13-1
ASSA ABLOY New Zealand Limited
6 Armstrong Road, Albany, Auckland 0632
[e-mail]
www.assaabloy.co.nz