Avantco A36292 User manual

Horse manure collector 2015 1
Operator's Manual for Attachment
Horse manure collector
Product number
A36292
www.avanttecno.com

Horse manure collector 2015 1

3 (6)
1. Designed purpose of use
The AVANT Horse manure collector is an attachment suitable for use with AVANT multi purpose loaders
shown in Table 1. The manure collector is a very useful attachment for handling and collecting horse manure
on different surfaces (saw dust, horse arenas). The horse manure collector is a simple and economical way to
collect horse manure.
The manure fork is equipped with replaceable tines. The fork should not be used for other purposes; for
compacted manure the manure fork is recommended. The fork is not designed to withstand loads from other
types of use than handling soft materials.
The attachment is maintenance free, except for cleaning, monitoring its condition, and occasional paint
retouch if needed. Larger repair work must be left for professional maintenance. Please contact your AVANT
retailer if you have additional questions about the operation or maintenance of the equipment.
2. Safety
When operating the Horse manure collector, follow safety instructions given in the
operator's manual of the base attachment and the operator's manual of the loader.
3. Technical specifications
Table 1 - Technical specifications
Product number
A36292
Width:
950 mm
Tine length:
368 mm
(from bucket edge)
Gap beteween forks:
23 mm
Number of forks:
13 (double tines)
Fits to:
All Avant buckets with straight edge

4 (6)
.
Table 2 - Main components of the Horse manure collector
1
Frame, with 2 locking bolts to clamp on bucket edge
2
Double tine (13 pcs)
3
Tine holder
1
13
A417852
2
13
A417854
3
13
74912 M8x60
4
13
72320 & 73122
5
2
74988 72321
4. Using the Horse manure collector
When collecting material with the collector
floor:
Keep the bucket low and at a low angle
Drive slowly and carefully

5 (6)
Collision hazard - Never keep
the bucket lifted or at high angle
relative to the floor while
collecting. Hitting any obstacle
can cause sudden stopping of
the machine and damage.
5. Warranty terms
Avant Tecno Oy grants a warranty of one year (12 months) from the date of purchase for the attachment it
manufactures.
The warranty covers repair costs as follows:
Work costs are covered, if the repair is not performed at the factory.
The factory replaces any defective components or consumables.
The factory may reimburse the price of components purchased by the customer in special cases that have
been agreed in advance.
The warranty does not cover:
Normal maintenance work or parts and consumables required for it.
Damages caused by unusual operating conditions or ways of use, negligence, structural changes made
without the consent of Avant Tecno Oy, use of non-original parts or lack of maintenance.
Consequences of a defect, such as interruption of work or other possible additional damages.
Travel and/or freight costs caused by the repair.