Avery Dennison TrafficJet Manual

Avery DennisonⓇⓇ
TrafficJet™ Purex Fume Extractor
Instructional Bulletin : # 9.17
Revision : # 02
Last Updated : June 2018

Contents
●Installation
●Control System
○Switch ON the Machine
○Adjust the Airflow
●Replacing the Filters
○Changing the Main Filter
○Changing the Pre-Filter
●Warning Alerts
○Warning Status
○Alarm Status
●Changing the Fuse
●Contact Information Purex







































Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 1 of 6
reflectives.averydennison.com

Installation
1. Position the fume extractor as near as possible to the TrafficJet printer allowing for easy access to                
the control panel, filter replacement, exhaust, electrical, and hose connections. Once in place,            
lock all casters.
2. Connect the extraction hose to the intake of the fume extractor and the other end of the hose to                  
the supplied Maintenance Cover. Make sure all connections are properly sealed.
3. Remove the Left Maintenance Cover of the TrafficJet and replace it with the New Maintenance              
Cover connected to the fume extractor.





4. Connect the power supply cable to the fume extractor and plug in the extractor to a dedicated                
power source.
5. While the TrafficJet printer is not printing or cleaning, go to the user panel and select “Menu”.                
Scroll through until you reach “18 Exhaust Fan” and select “OFF”.





Turn OFF the Printer’s exhaust fan while the fume extraction system is running in order to achieve                
maximum efficiency.








Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 2 of 6
reflectives.averydennison.com

Control System
Switch ON the machine
Press the center button on the keypad. The center button will illuminate green and the motor-run-icon on                
the display will rotate. To turn the extractor off, press the center button again and the light will go off and                    
the icon will stop rotating.




Adjust the airflow
Press the UP and DOWN buttons together and both will begin to flash red. To increase the airflow rate                  
press UP, to decrease press DOWN.





Recommended airflow rate: 150 CFM / 255 m3/h. Setting this value higher, can disturb the airflow inside                
the machine in such a way, the printing process can be affected in a negative way.

Please note that this solution should be considered a recommendation and possible addition to reduce the               
fumes and odor. Additional extraction or adjustments might be required to be compliant with local health               
and safety regulations.

After a few seconds the buttons will stop flashing the airflow rate value will be stored. The fume extractor                  
will now maintain the correct airflow level without further user input during TrafficJet printing.









Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 3 of 6
reflectives.averydennison.com

Replacing the Filters
Filters should be replaced annually.

To avoid airflow false alerts, always check the extraction hose and air intakes for debris buildup before                
replacing filters.

In case the filters need replacement sooner or in between, the fume extractor will warn the user with                 
audible and visible alerts. Icons on graphic display will flash indicating the filters needing attention. Always               
wear protective gloves, eyewear, and masks when disposing of the used filters. Place the old filter into the                 
provided disposal bag.

Before replacing the filters

1. Make sure printing on the TrafficJet is stopped
2. Turn off the fume extractor

Changing the Main Filter

1. Turn the door lock on the front of the extractor and open the door.
2. Turn the filter locking handle 180º counterclockwise so it is horizontal. The filter should drop              
slightly to allow release.




3. Remove the filter by sliding it towards the user and remove it completely from the machine. Be                
careful as the filter may be heavy
4. Insert the new filter fully into the machine making sure that the airflow arrow on the label is                 
pointing up.










Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 4 of 6
reflectives.averydennison.com


Changing the pre-Filter
1. To remove the pre-filter pad, the main filter must be removed first and turned over
2. Remove the older pre-filter and replace it with a new one making sure the smooth side of the                 
pre-filter pad is facing the main filter
3. Turn the filter locking handle 180º clockwise so that it is horizontal
4. Close and lock the door. The machine may now be restarted


Warning alerts
Warning Status
An audible chime every 20 seconds while the keypad flashes red every 10 seconds is designed to give the
user advanced warning so that action can be taken.
Alarm Status
An audible chime and keypad flashing every 1 second means immediate action must be taken.





The three columns on the graphic display correspond to three alerts. The far left column is for “Filter
Blocked Warning”. The middle column above the respirator icon is for “gas sensor” and the right column
warning is for “Particulate Sensor”.

Please see the Purex Manual for further details.


Changing the Fuse
1. Make sure the machine is disconnected from the main power supply
2. Remove the fuse by unscrewing the fuse cap with a screwdriver counterclockwise and remove the              
fuse
3. Check the fuse holder for any damage. If there is damage contact Purex Technical Support
4. Replace with a new fuse of correct rating. Please contact Purex if there is a question of                
compatibility
5. Reattach the fuse cap and turn it 1¼ full turns clockwise





Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 5 of 6
reflectives.averydennison.com



Contact Information
Purex International Ltd (UK)
Purex House, Farfield Park, Manvers
Rotherham
South Yorkshire
S63 5DB
Web: www.purex.co.uk
Tel: [phone]
Fax: [phone]
E-mail: [email protected]

Hours of Operation
Monday-Thursday 8.00am to 5.30pm
Friday 8.00am to 2.00pm

Purex Inc.
2246 Palmer Drive, Suite 108
Schaumburg
Illinois 60173
United States
Web: www.purexinc.com
Tel: [phone]
E-mail: [email protected]

Hours of Operation
Monday-Thursday 8.00am to 5.30pm
Friday 8.00am to 2.00pm










The above Avery Dennison literature provides information to the user for proper application, storage and other requirements. Please refer to Product Data
Bulletins or your local Avery Dennison Representative for warranty information. Find the latest information on the Avery Dennison website,
www.reflectives.averydennison.com. We encourage you to check our website periodically for updates.

All statements, technical Information and recommendations about Avery Dennison products are based upon tests and information believed to be reliable, but do
not constitute a guarantee or warranty of any kind. All Avery Dennison products are sold with the understanding that Purchaser has independently determined
the suitability of such products for its intended and other purposes.

For technical questions, please contact:

North America: [email protected]
Europe, Middle East & Africa: [email protected]
Asia Pacific: [email protected]
South America: [email protected]

Instructional Bulletin IB# 9.17
TrafficJet™ Purex Fume Extractor
Page 6 of 6
reflectives.averydennison.com