AXIOMTEK eBOX532-100-FL Series User manual

©Copyright 2016 Axiomtek Co., Ltd.
Version A3 Jan 2016
Printed in Taiwan
9416K532020E
4
Installing the Hard Disk Drive
Step 1 Turn off the system, and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the bottom,
loosen screws to remove the back cover.
Step 3 Assembly the HDD bracket, together with the HDD Mylar, and fix it
all into the system, and plug the power cable in HDD.
Step 4 Close the cover to the chassis, and fasten all screws.
MAXIMUM DEPTH OF THE HDD BRACKET : 2.5mm (when installing DIN
Mount)
D E P T H 2 . 5 m m M A X .
eBOX532-100-FL Quick Installation Guide
©Copyright 2016Axiomtek Co., Ltd.
Version A3 Jan 2016
Printed in Taiwan
9416K532020E
1
Packing List
eBOX532-100-FL System Unit
x 1 Y Cable for PS/2 Keyboard & Mouse x 1
eBOX532-100-FL Quick
Installation Guide x 1 CD x 1 (for Driver and User’s Manual)
Power Cord x 1 25W 5V AC/DC Power Adapter
x 1
Wallmount Bracket x 2 HDD Mylar x1
M3x4 Screws x 4
Do not try to apply power to the system if any damaged
components.
Dimensions
eBOX532-100-FL Series Fanless Embedded System

©Copyright 2016 Axiomtek Co., Ltd.
Version A3 Jan 2016
Printed in Taiwan
9416K532020E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX532-100-FL Series
Front View
Rear View (eBOX532-100-VGA-FL)
Rear View (eBOX532-100-PGA-FL)
COM1/2
CONNECTORS
4 x USB 2.0
CONNECTORS
AUDIO
CONNECTOR
PS/2
CONNECTOR
POWER-ON
SWITCH
VGA
CONNECTOR RJ-45
CONNECTOR FOR
ETHERNET
5V DC-IN POWER
INPUT
CONNECTOR
POWER-ON
SWITCH
DISPLAYPORT
CONNECTOR RJ-45
CONNECTOR
FOR ETHERNET
5V DC-IN POWER
INPUT
CONNECTOR
©Copyright 2016Axiomtek Co., Ltd.
Version A3 Jan 2016
Printed in Taiwan
9416K532020E
3
Installing the Memory Module
Step 1 Turn off the system, and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the bottom,
loosen screws to remove the back cover.
Step 3 Locate the memory module, insert the gold colored contact into the
socket. Push the module down, until it is firmly seated by locking
two latches on the sides.
Step 4 Close the cover to the chassis, and fasten all screws.