AXIOMTEK KIWI310 User manual

4 © Copyright 2021 Axiomtek Co., Ltd.
Version A1 September 2021
Printed in T iw n
Quick Start
The basic procedures required to power on KIWI310:
(1). Assemble thermal solution with KIWI310 properly as indicated in
image below.
(2). Check all switch settings and make sure they are at default settings;
especially the Auto Power On setting on KIWI310 board must be
enabled (SW1-1 ON).
(3). Make sure that all necessary peripheral devices are plugged properly
(4). Firmly insert USB type C power adapter or power bank into connector
CN7. The power requirement:
- For 9V input voltage, the minimum current requirement is 1.1A.
- For 20V input voltage, the minimum current requirement is 0.5A.
(5). Power on the system by inserting power plug.
Heatsink
KIWI310
KIWI310 Quick Installation Guide
© Copyright 2021 Axiomtek Co., Ltd. 1
Version A1 September 2021
Printed in T iw n
Checklist

1
.
8
”
B
oard x1

Heatsink
x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Board Layout
Top View
KIWI310 Intel
®
Celeron
®
N3350 Processor 1.8
”
Board

2 © Copyright 2021 Axiomtek Co., Ltd.
Version A1 September 2021
Printed in T iw n
Side View
Bottom View
© Copyright 2021 Axiomtek Co., Ltd. 3
Version A1 September 2021
Printed in T iw n
Switch Settings
Before applying power to the KIWI310, please make sure all switches are in
factory default position.
Switch Description Setting
SW1
Auto Power On
Default: Enable SW1-1 ON
Restore BIOS Optimal Defaults
Default: Normal Operation
SW1-2 OFF
Connectors
Connector
Description
CN1 40-pin GPIO Header
CN
2
POE Header
CN3
Ethernet Port
CN4 USB 3.2 Port 1 and 2
CN5
M.2
2230
K
ey
E
Connector
C
N6
USB
2.0 Port 1 and 2
CN7
Power Connector
CN8
Micro HDMI Connector
CN9 Power and Reset Button
BAT1
CMOS Battery Connector