AXIOMTEK tBOX400-510-FL Series User manual

4 9416N400000E
© Copyright 2019 Axiomtek Co., Ltd.
Version A1 anuary 2019
Printed in Taiwan
Step 5 Install the DDR module with caution and put the
thermal pad on the DDR module again. Then screw
the DDR cover to finish the installation.
tBOX400-510-FL Quick Installation Guide
9416N400000E 1
© Copyright 2019 Axiomtek Co., Ltd.
Version A1 anuary 2019
Printed in Taiwan
Packing List

System U
nit
x
1

HDD Mylar x 4
Quick Installation Guide x 1 SATA Drive Key x 2

D
CD x 1 (for
Driver
s
)

D
RAM
Thermal Pad x 4

Foot Pad x 4

Wall
M
ount
Bracket
x
2

Screw
P
ack
x
1
Note: Please contact your local distributor if any of the above-mentioned
items is missing or damaged. DO NOT apply power to the board if any
component is damaged.
Dimensions
tBOX400-510-FL Embedded System

2 9416N400000E
© Copyright 2019 Axiomtek Co., Ltd.
Version A1 anuary 2019
Printed in Taiwan
I/O Outlets
The following figures show the I/O outlets on the front panel of the
tBOX400-510-FL series.
▼
▼▼
▼Front View
Installing the HDD/SSD
Step 1 Attach a Mylar on the HDD/SSD and screw the
HDD/SSD on the tray.
Step 2 Install the SATA drive into the slot and fasten the
screw to lock the SATA drive to complete the
installation.
9416N400000E 3
© Copyright 2019 Axiomtek Co., Ltd.
Version A1 anuary 2019
Printed in Taiwan
Installing the DDR Module
Step 1 Make sure the system is powered off and unplug the
power cord.
Step 2 Turn the tBOX400-510-FL upside down, loosen the
cover screws and lift the bracket a little bit as shown.
Step 3 Disconnect the four SATA connectors and remove the
bracket.
Step 4 Loosen below screws to remove the cover and put the
thermal pad on the slot.