AXIOMTEK IPC922-215-FL User manual

4 9416G922020E
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 January 2016
Printed in Taiwan
Step 5 Align the PCI or PCIe card with the slot, and press the
card into the slot until it is firmly seated.
Step 6 Close the top cover back to the chassis and fasten all
screws.
IPC922-215-FL Quick Installation Guide
9416G922020E 1
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 January 2016
Printed in Taiwan
Checklist
IPC922-215-FL System Unit x 1 Driver CD x 1
Wall Mount Bracket x 2 Quick Manual x 1
Food Pad x 4 Screw Pack x 1
BTX Cable 2P for Remote SW
Cable x 1 HD Bracket x 1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Installing the Memory Module
Step 1 Turn off the system, and disconnect the power
connector.
Step 2 Loosen screws to remove the top cover from the
chassis.
Step 3 Please follow steps below to install the memory module:
1. Align the memory module with the socket that notches of
memory module must match the socket keys for a correct
installation.
2. Install the memory module into the socket and push it
firmly down until it is fully seated. The socket latches are
clipped on to the edges of the SO-DIMM.
INSERTING MODULE
MODULE FULLY SEATED
IPC922-215-FL Fanless System

2 9416G922020E
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 January 2016
Printed in Taiwan
Installing the Hard Disk Drive
Step 1 Turn off the system, and disconnect the power
connector.
Step 2 Loosen screws to remove the top cover from the
chassis.
Step 3 Open the top cover and locate the Hard Disk Drive from
the side. Use assembly parts to fix HDD with the
bracket.
HDD LOCATION
ASSEMBLING HDD BRACKET
Step 4 Install and fix the HDD through the bottom, next, plug
the power cable in HDD
INSTALLING HDD HDD FIXED
9416G922020E 3
©Copyright 2016 Axiomtek Co., Ltd.
Version A1 January 2016
Printed in Taiwan
Installing the PCI or PCIe Card
Step 1 Turn off the system.
Step 2 Disconnect the power connector.
Step 3 Loosen screws to remove the top cover from the
chassis. Removing the PCI or PCIe bracket by
releasing the button as marked.
Step 4 Locate the PCI or PCIe slots from the top.