baby&child Tribeca Wide Dresser User manual

WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.

FURNITURE TIPPING RESTRAINT:
Young children may be injured by tipping furniture and the use of a tipping restraint is highly
recommended. When properly installed, this restraint could provide protection against the
unexpected tipping of furniture due to small tremors, bumps or climbing. We recommend
mounting this restraint to a wall stud.
(4) Phillip screws M4x20mm
(4) Plastic anchors
TOOLS NEEDED:
- Phillips head screwdriver (not provided)
HARDWARE LIST:
(4) Plastic brackets
(2) Restraint straps
(4) Phillip screws M4x30mm
6. Lace one end of the nylon restraint straps down through each bracket. Bring both ends together and
slide the beaded ends until it snap locks into the keyhole slot.
7. To double lock; return the beaded ends back through the keyholes as shown.
8. Check to make sure the straps are securely laced and locked to the brackets.
ASSEMBLY INSTRUCTIONS :
1. Attach one set of the mounting brackets near the top back edge of the furniture piece by inserting the
shorter screws.
2. Determine the final position of the furniture piece. Mark locations on the wall approximately 2" below the
brackets mounted to the back of the furniture.
3. Drill starter holes into the wall stud. If wall stud is not available, drill holes into the wall and insert plastic
anchors. Gently tap the anchors until the flange of the anchors is flush with the wall.
4. Attach the second set of brackets by inserting the longer screws through the brackets and into the wall.
5. Place the furniture so the brackets on the back edge are in line with the brackets in the wall.
WARNING:
When the item is stationary, please turn the
wheels towards front and lock. This is to
offer best stability.