baby&child WILKES TRUNK User manual

D E S C R I P T I O N
NO QTY
8PCS
8PCS
8PCS
1 PCS
2
3
4
PHILLIPS WOOD SCREW
16 PCS
4
WILKES TRUNK 2-DRAWER STORAGE BED WITH HEADBOARD
WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL
PARTS, SHARP POINTS AND EDGES
PART LIST
A. HEADBOARD
B. TRUNK STORAGE
C. FOOTBOARD
D. COVER PANEL
IMPORTANT
These bed parts can be cumbersome and heavy to some people, therefore the assistance of two or
more people is recommended in order to prevent personal injury and ensure the bed parts are not
damaged during the assembly Process.
HARDWARE LIST
Customer Service - If you are missing parts or have any questions about this product please
contact us at 1-800-762-1751
LOCK WASHER
PLAIN WASHER
ALLEN WRENCH
ALLEN HEAD BOLT
Page 1 of 2

INSTRUCTIONS
The bed is composed of several components,
the headboards, trunk storage, footboard
and twin cover panel. Determine the
intended location and ensure there is enough
space to work with and fully read these
instructions before physically doing the
entire assembly.
STEP #1:
Place the bed parts on a plain and
non-abrasive surface. Remove the drawer
and twin cover panel of the trunk storage (B)
to have a full access to the holes on both
corner ends. Please see figure 01.
STEP #2:
Place the headboard (A) upright in the
position you wish the bed to be in when fully
assembled. The headboard (A) bed fast
hardware should be facing inside, toward the
storage trunk. Bring the headboard (A)
against the trunk storage (B) then locate and
align the wooden dowels into the holes of
the headboard (A), once the bed storage
drawer (B) is set, fasten these with Allen
head bolt (1) together with lock washers (2)
and plains washers (3) provided. Tighten the
bolts with Allen wrench (4) to snug fit.
Please see FIGURE 02.
STEP #3:
Repeat the above procedure with the other
bed storage drawer (B) to attach it to the
headboard (A), and then repeat to connect
the bed storage drawer (B) to the footboard
(C).
STEP #4:
Set the twin cover panel on top of the trunk
storage and fasten these with screws (5)
provided as in figure 03 and then Insert
drawers back to each bed storage drawer
compartment.
FIGURE 01
FIGURE 02
FIGURE 03
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2