baby&child CHESTERFIELD User manual

PARTS INCLUDED
A[2] Side Panel
B [1] Front Panel
Headboard
D [1] Trundle
E [4] Slats
F [2] Patform Panels
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Stand the Headboard (C) upright and hook Side Panels (A) into Headboard (C) as shown in
the Diagram I.
2. Repeat the procedure with the Front Panel (B) as shown in Diagram II.
AC
[1]
C
D
E
F
B
Page 1 of 2
NO. Qty
1 Allen Key 1 pieces
2 Allen Head Bolt(0.6cm Dia) 2 Pieces
3 Allen Head Bolt(0.8cm Dia) 2 Pieces
4 Screw(3cm) 8 Pieces
5 L-Shaped Bracket 2 Pieces
DESCRIPTION
[1] Center Support Slat
3.
4.
Attach the L-Shaped Brackets(5) onto the ends of Center Support Slat (C), and tighten with
Allen Head Bolt (2) & Allen Key (1). Attach the L-Shaped Brackets (5) onto the Headboard(C)
and tighten with Allen Head Bolt (3) & Allen Key (1),as shown in Diagram III
5.
Place the Slat (E) into the cleats on the inside of the Headboard (C) and Footboard (B). Screw the
ends of the Slats (E) to the cleats using Screws (4), as shown in Diagram V.
G
[1] Center Support Foot(with adustable glide)
Lay the Patform Panels (F) flat on top of the Slats (E).
. Push the Trundle (D) into the Daybed frame, making sure the Trundle (D) front panel is flush
with the Daybed Front Panel (B).
6
CHESTERFIELD DAYBED FULL W/TRUNDLE

CARE INSTRUCTIONS
Spot clean only with a soft, damp cloth.
Diagram I
Diagram II
Diagram III
Diagram V
A
A
A
A
C
C
B
B
D
G
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2