baby&child MARCELINE DAYBED User manual

Customer Service - If you are missing parts or have any questions about this product please contact
us at 1-800-762-1751
TOOLS NEEDED
IMPORTANT
These bed parts can be cumbersome and heavy to some people; therefore the assistance of two or
more people is recommended in order to prevent personal injury and ensure the bed parts are not
damaged during the assembly process.
M A R C E L I N E D A Y B E D
PART LIST
A HEADBOARD [1]
B END PANEL [2]
C FRONT RAIL [1]
D TWIN PANEL SUPPORT [3]
E TWIN PANEL [2]
F TRUNDLE (OPTIONAL, SOLD SEPARATELY)
WARNING: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS, SHARP POINTS
AND EDGES.
-PHILLIPS HEAD SCREWDRIVER (NOT PROVIDED)
HARDWARE LIST
Page 1 of 3
NO.
1
HEX NUT
THREADED ROD
CURVED WASHER
LOCK WASHER
D E S C R I P T I O N QTY.
4 PCS
4 PCS
4 PCS
4 PCS
WRENCH 1 PC
PHILLIPS WOOD SCREW 18 PCS
2
3
4
5
6
E
E
F
C
D
D
A
B
B

FIGURE 01
FIGURE 02
FIGURE 03
ASSEMBLY INSTRUCTIONS:
Thank you for choosing this quality product. Be sure to
check all packaging materials carefully for small parts
that may have become loose during shipment and place
all parts on a non-abrasive surface.
STEP #1:
Place the Headboard (A) and the End Panels (B) upright
in the position you wish the bed to be in when fully
assembled. On connecting end of the End Panels (B) are
pre-installed hooks that correspond to the cavities on
both ends of the Headboard (A). Align and insert the
hooks on the End Panels (B) into the cavities on the
Headboard (A). Please see FIGURE 01.
Note:
On both ends of the End Panels (B) are holes with pre
installed nuts and holes for the wooden dowels to pass
through that correspond to the holes on both ends of
the Front Rails and pre-installed wooden dowels.
STEP #2:
To install the Front Rail (C), fasten the Threaded Rod (1)
manually into the insert nut on both End Panels (B).
Insert the wooden dowels of the Front Rail (C) onto the
mating hole of both End Panels (B) as well as the
Threaded Rod of End Panels (B) into the mating holes of
the Front Rail (C). Insert Curved Washers (2) and Lock
Washers (3) and engage Hexagonal Nuts (4). Tighten
all the nuts with Wrench (5) provided. Please see
FIGURE 03.
NOTE:
After assembly, re-tighten all bolts to a snug fit.
STEP #3.
On the inside face of the Headboard (A) and Front Rail
(C) are cleats with cavities for the Twin Panel Supports
(D). Set the Twin Panel Supports (D) into the cleats and
fasten both ends with Screws (6) provided. Please see
FIGURE 03.
Page 2 of 3

FIGURE 04
FIGURE 05
STEP #4.
Set the Twin Panels (E) on top of supports (D)
and fasten these with Screws (6) provided as in
FIGURE 05.









STEP #5
After assembly, slide the optional Trundle (sold
separately) (F) underneath the Daybed as in
FIGURE 06.
Thank you for your purchase
www.rhbabyandchild.com
Page 3 of 3