baby&child PALOMA DRESSER TOPPER User manual

PALOMA DRESSER TOPPER
Page 1 of 2
WARNING:
FALL HAZARD - To prevent death or serious injury from falls, always keep child within arm's reach.
NEVER LEAVE CHILD UNATTENDED and always use restraining system.
This changing table is intended for use with children weighing up to 30 pounds.
Do not use the Paloma Dresser or Topper if damaged or broken.
Customer Service- If you are missing parts or have any questions about this product, please contact us at:
1-800-762-1751
IMPORTANT SAFETY INSTRUCTIONS:
Please read all instructions before use of the Dresser or Topper.
For your safety, assembly by two or more adults is recommended. Keep instructions for future use.
HARDWARE INCLUDED:
A [2] Mending Plates
B [4] Phillips Head Screws
PRE-ASSEMBLY:
The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
Remove all parts and hardware from the box and lay out on a carpeted or scratch-free work surface. The
shipping box provides an ideal work surface. Do not dispose of any contents until assembly is completed to
avoid accidentally discarding small parts or hardware.
Use the parts on the hardware list to identify and separate each of the pieces included prior to starting
assembly.
Note: Do not fully tighten the screws until all parts are in place. Failure to follow these instructions may
cause the screws to misalign during assembly.
If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood

ASSEMBLY INSTRUCTIONS:
CARE INSTRUCTIONS:
1. Dust often using a clean, soft, dry lint-free cloth.
2.
Blot spills and absorb immediately, wipe with a clean, dry, lint-free cloth.
3.We do not recommend the use of chemical cleansers, abrasives, or furniture polish.
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2
A
C
D
B
PALOMA DRESSER TOPPER WHITE
Place the dresser topper [A] on top of the dresser [B], and check the distance on both sides
to make sure the dresser topper is centered correctly with the help of pilot holes. Secure the
metal brackets [C] to the back of the dresser [B] and to the back of the dresser topper [A]
with screws [D].