baby&child MADIGAN WING BED User manual

PARTS INCLUDED
A [1] Headboard
B [2] Side rail
C [1] Footboard
D [10] Cross support Slat
E [1] Center Support Slat
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly iscomplete to avoid loss of smaller parts.
Page 1 of 2
F [1] Center Support Slat Foot
(With adjustable glide)
1.
4.
5.
Repeat above procedure to attach the Footboard (C), as shown in the Diagram II.
6. Place the Slat Roll (D) on the cleats on the inside of the Side Rail (A). Screw the ends ot the Slats
to the cleat using Screw (6), as shown in Diagram V.
Stand the headboard (A) upright and align the Side Rails (B) at the base of the headboard.
Attach the L-Shaped Brackets (10) to the ends of Center Support Slat (D), and tighten Allen
Head Bolt (8) with Allen Key ( ). Attach the L-Shaped Brackets (10) to the Headboard (A).
and Footboard (C) and tighten Allen Head Bolt ( ) with Allen Key ( ), as shown in Diagram IV.
9
7
Insert the Thread Rods (1) into the holes on the Side Rail (B), and attach Curved Washers (2),
Tighten the Nuts (4) & Thread Rods (1) with Spanner Wrench (5) as shown in the
Diagram I.
3.
2.
Attach the Center Support Slat Foot (F) to the Center Support Slat (E), as shown in the Diagram III.
7
Lock Washers (3),
Nuts (4) onto the Thread Rods (1).
L ock Washer
MADIGAN WING BED
20 pcs
CARE INSTRUCTIONS
1. Spot clean only with a soft, damp cloth.
2. Do not use abrasive cleanser.

C
Page 2 of 2
Diagram IV
8
1
23456
F
A
B
E
7
10 Diagram II
Diagram III
D
Diagram I
Diagram V
7
2345
1