baby&child ASHER User manual

ASHER CANOPY BED
WARNING:ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS, SHARP
POINTS AND EDGES
Customer Service- If you are missing parts or have any questions about this product, please contact us
at : 1-800-762-1751
PART LIST
A [1] HEADBOARD PANEL
B [2] SHORT CANOPY POSTS
C [2] LONG CANOPY POSTS
D [1] FOOTBOARD PANEL
E [2] SIDE RAILS
F [1] SLAT ROLL
G [4] CANOPY RAILS
H [4] CONNECTION BLOCK
K [4] CANOPY FINIALS
HARDWARE LIST
Curved slotted washe
r
ASSEMBLY INSTRUCTION
Note: Two adults are recommended to assemble this bed.
1. Place the headboard panel (A) upright in the position you wish the bed to be in when fully
assembled. The headboard bedfast hardware should be facing the inside, toward the mattress. Place
the hooks in the Headboard panel (A) into the slots in the Short canopy posts (B).
- Page 1 of 3 -

2. Let the Footboard panel (D) lay flat on smooth surface like packing foam. Secure the threaded rod
(3) to the Long canopy posts (C) and place the rod into the Footboard panel (D) at the bore holes’
position, insert Curved slotted washer(4), hex nuts (1) and tighten hex nuts using wrench (7).
Repeat the procedure with other side.
3. The side rails (D) are not handed parts so either rail will work on the right or left side. While
holding the Headboard panel (A) up attached to Canopy posts (B), place the hooks in the rail into
the slots in the Canopy posters (B). Using a thick magazine or book to protect the side rail seat the
hook-rail with a mallet or hammer until tight. Repeat the procedure with the other rail (C). The
Headboard (A) will now stand on its own with the rails supporting it. (See drawing on page 3). It
might be a good idea to place something under each rail (D) to elevate them so they are level,
making it easier to place the footboard (C) onto the rails (D), but is not necessary. Insert the rail
hooks into the slots in the footboard (B) and seat using the method described above.
Our hook-rail construction allows you to adjust the height of the bed for 2 settings. The higher
setting is for use with a trundle and for use without a box spring. The lower setting is for use with
a box spring. To insure the correct setting please measure the following distances:
Higher setting- distance from the floor to the bottom of the hook-rail measures 11.5”.
Lower setting- distance from the floor to the bottom of the hook-rail measures 7.5”.
4. Lay the slat roll (F) in between the side rails (E) and use wood screws (2) to fasten 2 end slats to
the side rails with a screwdriver.
- Page 2 of 3 -

5. Insert connecting bolts (5) to the Connection block (H). Then secure the Canopy rails (G) to the
Connection block (H). Place cam lock wheel (6) into the holes inside of the canopy rails by aligning
the arrow sign of the cam lock wheel to the connecting bolt and twist to tighten by counter
clockwise direction using Phillip head screwdriver (not provided). Repeat the same procedure to
the other 3 connection points of canopy set.
6. This final procedure should be done by 2 people working together to carefully lift assembled
canopy and place on top of bed posts. Insert the canopy finials (K) into the holes of Connection
block (H). Tighten with allen key (7). (See drawing as below).
Thank you for your purchase
www.rhbabyandchild.com
- Page 3 of 3 -