baby&child OGDEN User manual

OGDEN DRESSER
WARNING : ADULT ASSEMBLY ONLY OWING TO THE PRESENCE
OF SMALL PARTS, SHARP POINTS AND EDGES
!
4 SCREWS
Page 1 of 2
4 ANCHORS
(FOR DRY WALL)
2 SETS ANTI - TIP HARDWARE
: If you are missing parts or have any questions about this product Customer Service
please contact us at : 1-800-762-1751
TOOLS NEEDED :
Phillips head screwdriver (not included)
HARDWARE TO ATTACH UNIT TO WALL :
WARNING :
Young children may be injured by tipping furniture so proper installation of the mounting
hardware for this item is highly recommended. When properlry installed, this mounting
hardware could provide protection against the unexpected tipping of the furniture piece.
This product is only a deterrent. It is not a substitute for proper adult supervision.
CARE INSTRUCTIONS :
To clean, wipe with a soft cloth.
Avoid use of harsh chemicals or abrasive cleaners as these may damage the finishes.

FURNITURE TIPPING RESTRAINT INSTRUCTIONS
Thank you for your purchase
www.rhbabyandchild.com
Page 2 of 2
1
Install anti tip hardware on wall
with screws at the level of brackets
welded on the Dresser.
2
ASSEMBLY INSTRUCTIONS
1. Determine the final position of the furniture piece. Mark locations on the wall approximately 2” below
height of the iron brackets on the back of the furniture piece.
2. Drill starter holes into the wall stud. If wall studs are not available, drill holes into the wall and insert
plastic anchors. Gently tap the anchors until the flange of the anchors are flush with the wall.
3. Install anti tip hardware with screws.
4. Hook the anchors to the back of the Dresser.
Attach the hooks to the
Bracket on the Back of the
Dresser.