Backyard Creations GALLOWAY 272-5437 User manual

Page 1
PATIO FURNITURE & ACCESSORIES
ASSEMBLY INSTRUCTIONS
IMPORTANT
ACOV112
CARE AND MAINTENANCE
SPECIAL WARNINGS!!!
LIMITED WARRANTY
FRAMES
CERAMIC TILE
Use clean water and mild detergent or commercially available ceramic tile cleaners as necessary. Do not use abrasive
materials or cleansers as they may scratch the surface of the tiles. Dry with soft cloth. We do not recommend repeated
removal of the tiles from the table rim. Do not use commercially available ceramic tile cleaners on table frame.
PLEASE TAKE PRECAUTION AND DO NOT ALLOW ANYONE TO CLIMB, STAND, CRAWL OR WALK ON TOP
OF THE TABLE.
Frames.
Finishes.
Fabrics.
Straps and/or wicker.
Umbrellas
Table tops
Warranty limitations:
Warranty exclusions:
Some states do not allow exclusion or limitation of incidental or consequential damages, so that limitation above may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to
state.
Cleaning
Maintenance
- Use mild soap and warm water. Do not use abrasive materials, cleansers or bleach products. Rinse with clean water
and dry thoroughly.
- Periodically clean and dry thoroughly. Be sure to drain any water accumulated inside the frames. To thoroughly
drain frames, remove foot caps and tilt the frames, if necessary, to remove all water. This is critical. Water allowed to accumulate
inside the frames and then exposed to sub-freezing temperatures can cause damage to the frame tubing. Such damage is not
covered under warranty. Always clean, drain and dry thoroughly before storing for the winter. For best results, always store or
cover your furniture when not in use. We recommend commercially available outdoor furniture covers. Any small nicks or
scratches can be covered with a light application of touch-up paint.
** When cleaning or moving large or heavy items, always have two people work together. Never drag furniture.
Frame construction is warranted against defects in material and workmanship for one year from purchase date.
Damage to frames or welds resulting from improper assembly or exposure to water and/or sub-freezing temperatures is not
covered.
Paint finishes are warranted against peeling, cracking and blistering for one year from purchase date provided
the unit has not been scratched or abraded. Chips and scratches resulting from normal wear and tear are not covered.
Fabric and cushions (if applicable) are warranted against separation at the seams for one year from purchase date.
Fading and/or discoloration resulting from exposure to the elements, oils, spills, fluids, chemicals, or any other cause is not
covered.
Straps and/or wicker weave (if applicable) are warranted against separation and tearing for one year
from purchase date. Fading and/or discoloration resulting from exposure to the elements, oils, spills, fluids, chemicals, or
any other cause is not covered.
. Umbrellas (if applicable) are warranted against defects in material and workmanship only for one year from
purchase date. Umbrella bases (if applicable) are not covered under any circumstance.
. Natural stone tabletops only are warranted against defects in materials or workmanship only for one year from
purchase date. All other table tops (including without limitation glass and faux stone) are not covered under any
circumstances.
This warranty is subject to the limitations set forth above. In addition, this warranty is made to the
original purchaser only, and is effective only when item(s) is purchased from one of our authorized dealers. This warranty is not
transferable. For warranty replacements based on warranty claims submitted within the first year of purchase, we will pay
shipping and handling charges within the continental North America. After the first year, shipping and handling charges are your
responsibility. We will not be responsible for charges associated with shipments outside the continental North America at any
time or for any reason.
This warranty is subject to the exclusions as set forth above. In addition, the following are excluded from
coverage under this warranty: any item used for commercial, contract or any other non-residential purpose; clearance items,
display models or items purchased "as is"; freight damage; items subject to misuse, abuse, neglect or lack of proper care and
maintenance (including without limitation as provided in any "care and maintenance guide"); normal wear and tear; damage
caused by acts of nature, acts of force majeure, vandalism, fire or other casualty, or improper assembly; hardware against
corrosion or rusting; purchased or replacement parts; and all plastic parts. Also excluded are loss of use or time; inconvenience;
money; travel; packaging; or incidental, special or consequential damages of any kind. Replacement of defective items as
provided herein shall constitute your sole and exclusive remedy for items which are not as warranted. In no event shall our
responsibility exceed the purchase price of the items found to be other than as warranted. This warranty is the exclusive
statement of your rights with respect to the defects in the items you have purchased and supersedes any other express warranty or
statement, written or oral, made in connection with the purchase and sale of such items. When used herein, the term "item" when
used in the singular, refers to the specific item found to be defective, and not to the entire set of which the item is a part.
·
·
·
·
·
·
SKU #272-5437
GALLOWAY BAR TABLE
Customer Service 1-800-416-3511
STOP PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE
ASSEMBLY. MAKE SURE YOU HAVE ALL THE PARTS AND
HARDWARE AS IDENTIFIED ON THE PARTS LIST.
CALL OUR CUSTOMER SERVICE CENTER AT 1-800-416-3511
BETWEEN 9:00AM AND 5:00PM (EASTERN TIME) MONDAY
THROUGH FRIDAY (CLOSED HOLIDAYS).
OR, VISIT OUR WEBSITE AT: www.agio-usa.com
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, RETAIN THE
INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT FOR
FUTURE USE. YOU ARE ENCOURAGED TO REGISTER YOUR
PURCHASE ON OUR WEBSITE AT www.agio-usa.com
.
.
MISSING PARTS? DAMAGED PARTS? DON'T GO BACK TO THE
RETAILER. WE CAN HELP YOU FASTER
FOR ADDITIONAL ONLINE VIDEO SUPPORT ON ASSEMBLY,
TROUBLESHOOTING, AND CARE AND MAINTENANCE OF YOUR
AGIO OUTDOOR FURNITURE, PLEASE VISIT OUR WEBSITE AT:
www.agio-usa.com

Step 1:
Do not attempt assembly if any parts are missing or damaged.
Step 2:
Hand
tighten 2-3 turns only.
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in carton against
the parts list. If you are missing any parts or unsure how to proceed with assembly, call our Customer Service
Center at 1-800-416-3511.
Attach the table leg-1 to the back frame by using two 1/4"x50 mm bolts and Ø6.5x1.0 mm washers as shown in the
. Guide bolts through the holes in the back frame, into the pre-drilled holes in the table leg-1.
Repeat for the leg-2.
F1igure
Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 3:
Hand tighten 2-3 turns only.
Attach the two table legs to the table top by using
four 1/4"x50 mm bolts and Ø6.5x1.0 mm washers as shown in the . Guide the bolts through the holes in
the legs, into the pre-drilled holes in the table top.
F2
Place the table top upside down on a flat, non-abrasive surface.
igure
Figure 1
Figure 2
K
H
I
KHI
A
B
E
C
HW0004
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
Ø6.5 X 1.0 MM
WASHER
PARTS LIST DESCRIPTION ORDER PART # QTY
1
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
1
HEX BOLT DRIVER
TABLE LEG-2
TABLE TOP
HW0006
FOOT CAP
FACTORY ASSEMBLY
1
FC0131
8
1/4" X 18 MM BOLT HW0908 2
SHELF
BOLT COVER HW0105 8
1
1
1/4" X 45 MM BOLT HW0909 2
1/4" X 50 MM BOLT HW0090 8
TABLE LEG-1
BACK FRAME 1
HW0495
Ø12.5 X 8 MM
WASHER
Ø .5X3 2
AT52873
AT52874
AT52875
AT52876
AT52877
HW0914
1/4" X 15 MM BOLT HW0467
HW0890
1
Ø15 X 8 MM
WASHER
Ø .5X2
1
1
BRACKET

Step 4: Hand tighten 2-3 turns only.
Hand tighten 2-3 turns only.
Attention : Positions 1 and 2 are the different heights you can choose from to place the shelf on. There is a bracket in position 2 where you can put the shelf up (when not in use)
or down (when in use).
Attach the shelf to the two legs by using the 1/4"x45 mm bolts and Ø12.5x3 mm washers bolts and washers as shown in the . Insert a
1/4"x18 mm bolt into table leg-1 as shown in the Attach the bracket to the back frame by using the 1/4"x15 mm bolts and Ø15x2 mm washers bolts and washers as
shown in the .
F3a
F 3b.
F3c
igure
igure
igure
J
G
F
Figure 3a
Figure 3c
DL
M
1
2
Step 5: Note:
Do not over
tighten
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to tighten all nuts and bolts. each bolt and nut must be tightened
a few revolutions at a time. In order to apply equal pressure to all bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts. Cover all bolts with bolt covers.
Step 6: With the help of another person, turn the table in the upright position. Your table is now ready for use. If you have any questions, please call our Customer Service Center at
1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under our warranty. Please read all instructions
carefully before assembly. If you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.
Figure 3b
AME03229K01
Page 3