Balanced Body Arm Chair User manual

Assembling the Balanced Body®Arm Chair
Now that you have opened up the box for your new equipment, please take the time to thoroughly inspect if for shipping damage
prior to assembly. If any issues are found, contact our customer service department at 1-800-PILATES or 1-916-388-2838 right away.
Please read each step thoroughly and look at the diagrams before doing anything.
Parts:
(Please use this list to make sure you have all the parts listed. If you are missing
a part, please contact our customer service department at 1-800-PILATES or
1-916-388-2838.)
TOOLS PART NUMBER QTY
5/32” Allen Wrench GEN9282 1
. .
PARTS
Armchair
Wheel bracket (with wheels) 615-002
Armchair rod (with 2 eyebolt &
2 springs
230-025 1
Bracket, armchair rod 616-155 1
Spring, Yellow (with eyebolt) SPR9002 (modified) 1
Spring, Purple (with eyebolt) SPR9461 (modified) 1
Neoprene Handles 101-016 1 pair
HARDWARE
Finish washer 210-050 2
Acorn nut, 1/4” GEN9181 2
Button head bolt, 1/4”-20 x
1-1/2” long
GEN9019 2
Lock nut, 1/4” GEN9021 4
Flat washer, 1/4” GEN9204 5
tools Needed:
»7/16” open end or crescent wrench
1. Slide the rod with two springs attached through the holes in
the armchair as shown in Figure 1. Make sure the bolt holes
on the wood frame and metal bar are on the same side of the
chair once it slides into place.
Figure 1: View looking at the underside of the Arm Chair showing correct spring
rod placement. (springs omitted for clarity)
2. Make sure the loops of the eyebolts on the rod are pointed
toward the chair as in Figure 1. Using the included bolts,
washer, and nuts, install the rod bracket as shown in Figure 2.
Figure 2: View looking at the underside of the Arm Chair showing correct spring
rod placement.
3. Tighten both bolts installed in the previous step.
Contact Us
1-800-PILATES | [phone]
pilates.com | [e-mail]
400-244 | 10.19.12

4. Install the two remaining eyebolts with springs into the rod as
shown in Figure 3. Make sure the loops of the eyebolts are
pointed toward the chair, and that the same color spring is
closer to the chair as on the other side.
Figure 3: Springs omitted for clarity.
5. Using the provided 5/32” Allen wrench, remove the three
screws at the bottom of the chair. Hold the included wheel
bracket up to the three holes and align the holes. Begin
threading all three screws into the chair before tightening any
of them. Then tighten.
6. Your Arm Chair is now ready to use.
QuestioNs?
Call Balanced Body Technical Support at 1-800-PILATES or
[phone].
Contact Us
1-800-PILATES | [phone]
pilates.com | [e-mail]
400-244 | 10.19.12