Band-it S038 User manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-627-3925
Document # PO6788 rev. B
© Copyright
BAND-IT-IDEX, Inc. 2003
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 2
S038 - BAND-IT
Center Punch Tool
Operating
Manual
1. Tool is designed specifically for 3/8” and 5/8”
center punch clamps only. Insert clamp in tool and
then insert wrench assembly. If you prefer, install
wrench assembly before clamp is inserted. Slot must
be aligned with clamp tail.
2. Start “pumping” ratchet wrench forward until proper
tension has been applied.
3. Place punch on clamp and while holding
tension with ratchet wrench, lock clamp by striking
punch once or more with hammer, depending on
object being clamped.
4. While holding tension with wrench, pivot tool up
against buckle, then backward several times to
break off clamp tail.
5. To loosen clamp tail, wind ratchet wrench until
tail is free. Remove ratchet wrench assembly and
clamp tail. Caution: Clamp tail may spring back
once released from tool nose.

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-627-3925
Document # PO6788 rev. B
© Copyright
BAND-IT-IDEX, Inc. 2003
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 2
S038 - BAND-IT
Center Punch Tool
Repair Parts List &
Warranty
Unless sold without warranty, BAND-IT products are warranted to be free from defective workmanship and/or
materials for a period of one year from the date of purchase. Warranty on tools is void if clamps not meeting
BAND-IT specifications are used, or if the tool is altered or abused in any manner, including lack of lubrication or
used for any purpose in any way not intended by the manufacturer as specifically covered by the instructions
accompanying the tool. Specific tool components, such as knives, blades and grippers, which are subjected to
normal wear, are excluded from this coverage, as component life depends on usage of the tool. Tools that are
repaired or sold as used by BAND-IT are subject to a warranty of 90 days from date of shipment. NO OTHER
WARRANTY OF ANY KIND WHATSOEVER, EITHER ORAL OR WRITTEN, INCLUDING IMPLIED
WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR OTHER WARRANTY
OF QUALITY IS EITHER EXPRESSED OR IMPLIED FOR THE PERFORMANCE OF BAND-IT PRODUCTS.
BAND-IT SHALL NOT BE LIABLE FOR SPECIAL, INCIDENTAL, AND/OR CONSEQUENTIAL DAMAGES,
EVEN IF BAND-IT HAS BEEN NOTIFIED OF THE POTENTIAL OF SUCH LOSS OR CLAIM. (8/02)
REPAIR PARTS LIST – S038 CENTER PUNCH TOOL
ITEM
NUMBER
PART
NUMBER DESCRIPTION
1 J02786* WINDING MANDREL ASSEMBLY
2 S20288 PUNCH HOLDER ASSEMBLY
*REPAIR PARTS MAY APPEAR DIFFERENT THAN ILLUSTRATED.
1 2