BDI CASCADIA User manual

C - 1/4-20 x 12mm Screws
4mm Socket Drive
x 4
A - 4mm Hex Driver x 1
B - 5/16-18 x 50mm Screws
4mm Socket Drive
6201 x 8
6202 x 6
CASCADIA
Designed by Matthew Weatherly
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. © 2016BDI
6201 6202 Revision: 05-05-16
Component List
CASCADIA are engineered for easy assembly. Carefully follow this procedure to prevent any damage.
Unpack and identify the components. The assembly workspace should be a non-marring surface such as clean carpet.
For missing hardware pieces, please contact BDI Customer Service at [e-mail].
For all other concerns, please contact your BDI Retailer.
6201 6202
ASSEMBLY INSTRUCTIONS
1
BDIUSA.COM [e-mail]
Placement and Maintenance
CASCADIA is designed for indoor use on level floors.
D - Table Assembly x 1
E - Left Leg x 1
F- Right Leg x 1
G - Horizontal Bar x 1
CASCADIA 6201 Desk CASCADIA 6202 Console
B
C
G
D
E
F
C
B

CASCADIA
6201 6202 ASSEMBLY INSTRUCTIONS
2 BDIUSA.COM [e-mail]
Step 1
Attach 1st Leg to Table Assembly
Identify Left and Right Legs. Notch on
Leg towards inside and back of desk.
Attach Leg using Screws (B) and
tighten with Hex Driver (A).
Step 2
Attach Horizontal Bar
Insert tab on Horizontal Bar (G) into
notch on inside of Leg. Attach 1 side of
Horizontal Bar (G) using Screws (C)
tighten with Hex Driver (A).
A
B
Identify Left and Right Legs.
Notch on Leg towards inside
and back of desk.
E
B
E
D
C
A
D
E
G
G
E
D
D
E
D

CASCADIA
6201 6202 ASSEMBLY INSTRUCTIONS 3 BDIUSA.COM [e-mail]
Step 3
Attach 2nd Leg and Horizontal Bar
Insert tab on Horizontal Bar (G) into
notch on 2nd Leg. Attach Leg to
Table Assembly (D) using Screws (B)
and tighten with Hex Driver (A).
Attach Horizontal Bar (G) to 2nd Leg
using Screws (C) and tighten with
Hex Driver (A).
G
C
A
F
F
B
A
B
F
D
Step 4
Adjust Levelers as necessary
Turn Desk or Console over onto Legs.
Position Desk or Console as desired
then turn black puck levelers by hand
to adjust as necessary.
Turn black puck leveler by hand
to adjust as necessary.
Recommended
2-person Step

CASCADIA
6201 6202 ASSEMBLY INSTRUCTIONS
4 BDIUSA.COM [e-mail]
D
Step 5 (6201 optional)
Change Drawer Positions
Place Desk or Console upside down
on clean carpet. Remove both
drawers. Fully extend drawers, then
press on release tabs to release
drawer from slides.
Remove screws from drawer slide
block using Hex Driver (A).
Step 6 (6201 optional)
Change Drawer Positions
Move drawer slide block over to
other position and align screws with
inserts.
Attach drawer slide block to Table
Assembly (D) and tighten screws
using Hex Driver (A).
Reinstall drawers and turn Table or
Console upright onto Legs.
Recommended
2-person Step
Recommended
2-person Step
A
A
D