BDI Revo 9981 User manual

RevoTM 9981
Assembly Instructions
6/2008
HIGH PERFORMANCE
FURNITURE FOR YOUR
HOME THEATER

2
Revo™Home Theater Furniture
Component List
www.bdiusa.com
customerser[email protected]
D - Phillips Screwdriver x 1
E - Allen Wrench x1
C - Retention Clip x 8
Pre-installed
A - Glass Shelf x 2
B - Shelf Pin x 8
Pre-installed
F - Swivel-Lock Pin x 2
Pre-installed
Position 2
Front
Position 1
NOTE: Choosing not to use the Swivel-Lock
Pins (F) will enable 360-degrees of rotation.
F
Your Revo™ Home Theater Furniture is engineered for easy assembly.
Carefully follow this procedure to prevent any damage.
Placement and Maintenance
Revo™ Home Theater Furniture is designed for indoor use on level
floors. Clean glass with glass cleaner. Clean steel parts and wood
veneer with a moist cloth.
Step 1
Unpack and identify the parts listed above.
The assembly workspace should be a non-marring surface such as
carpet. For missing hardware pieces, please contact BDI Customer
Service at: customerser[email protected]
All other concerns, please contact your local BDI Retailer.
Step 2
Revo 9981 features a swiveling base.
Note that Swivel-Lock Pins (F) are factory-installed at Position 2 to
prevent swiveling during shipment.
To enable swiveling motion of 15-degrees to left and 15-degrees to
right, use provided Allen Wrench (E) to remove both Swivel-Lock
Pins (F) from factory position (Position 2) and re-install them at Position
1.

3
Step 4
Secure Glass Shelves
To secure the shelves on your Revo unit, it is necessary to use
the Glass Retention Clip (C), which is secured by the Shelf Pin
(B).
1. Install the 8 Shelf Pins (B) at desired location, 4 shelf
pins per shelf.
2. Install Glass Shelves (A x 2)
3. Install Retention Clips (C) as shown in “Pin Assembly
Diagram”
4. Secure by tightening the Shelf Pin (B) with Phillips
Screwdriver (D).
A x 2
B
1
1
44
Pin Assembly Diagram
1 : Retention clip (C)
2 : Glass Shelf (A)
3 : Shelf Pin (B)
4 : Cabinet wall
Retention clip (C)
Shelf pin (B)
Step 3
Install Glass Shelves (A).
Detail of Shelf Pin
(B) and Retention
Clip (C)
D

4
Designed by Louis Lara.
These distinctive product configurations are protected by US
and international patents, trade dress, and/or copyright laws.
BDI is a trademark of Becker Designed, Inc.
All Rights reserved. ©2008, BDI
Step 5
Install Back Panel.
The back panel comes pre-installed. Follow illustrations below for installation and removal.
RevoTM 9981
6/2008