BDI CENTRO User manual

Designed by Matthew Weatherly.
These distinctive product configurations are protected by US and international patents, trade dress, and/or
copyright laws. Centro & BDI are trademarks of Becker Designed, Inc. All rights reserved. ©2015, BDI
Made in China. 02.16.2016 V2
H1 1/4-20 x 15mm
Screw x 16
H2 M4 x 37mm
Screw x 6
T1 4mm Hex Wrench
C6 File Bar Clip x 4
C2 Pull x 3
C4 Small File Bar x 2
H3 1/4-20 x 19mm
Screw x 3
C5 Large File Bar x 1
H4 Bumper x 2
C1 Glass Panel x 1
A1 Cabinet x 1
C3 Base x 2
Product Registration
Registering your new BDI product allows us to send you important
product updates, service information and helpful hints related to your
BDI products. Register today, and you will be entered to win free a BINK
table from BDI. www.bdiusa.com/product-registration/
Placement and Maintenance
Centro™Office furniture is designed for indoor use on level floors. Clean
glass with glass cleaner, and steel parts and wood veneer with a moist
cloth.
Your Centro™Office furniture is engineered for easy assembly. Carefully
follow this procedure to prevent any damage.
Do not use power tools for assembly of this product.
Step 1
Unpack and identify the parts listed below. The assembly workspace
should be a non-marring surface such as carpet. For missing hardware
pieces, please contact BDI Customer Service at customerservice@
bdiusa.com. For all other concerns, please contact your BDI retailer.
bdiusa.com
customerservic[email protected]om
CENTROTM 6417
MULTIFUNCTION CABINET
Tool Required:
Phillips screwdriver

bdiusa.com
customerservic[email protected]om
CENTRO 6417
MULTIFUNCTION CABINET
2
Step 2 - Install Base
Attach Base to Cabinet using Screws H1 and tighten with Hex Wrench.
Step 3 - Adhere Bumpers H4 as shown.
Step 4 - From below the top panel, attach Glass Panel with Screws H3 using Hex Wrench.
H3 (x3)
H4 (x2)
H1 (x16)

bdiusa.com
customerservic[email protected]om
CENTRO 6417
MULTIFUNCTION CABINET
3
Step 5 - Attach Pulls to Cabinet using Screws H2 and tighten with a Phillips screwdriver.
H2 (x6)
C6
C4
Inner Notch
(Legal File)
Outer Notch
(Letter File)
Step 6 - File Bar Installation (Option A)
For files facing forward, attach File Bar Clip C6 to both ends of Small File Bar C4 as shown.
For letter files, use the outer notches on the front and back of the drawer. For legal files, use the inner notches.

bdiusa.com
customerservic[email protected]om
CENTRO 6417
MULTIFUNCTION CABINET
4
Step 7 - File Bar Installation (Option B)
For letter files facing sideways, attach File Bar Clip C6 to both ends of Large File Bar C5 as shown. Place
the file bar assembly in the notches located on the left and right drawer side panels. For side facing legal files,
skip this step altogether.
C5
C6