BDI MILO 1055 User manual

1
Product Registration
Registering your new BDI product allows us to send you important
product updates, service information and helpful hints related to
your BDI products. Register today, and you will be entered to win
free a BINK table from BDI: www.bdiusa.com/register
Placement and Maintenance
Your MILO Media Table is designed for indoor use on level floors.
Clean wood veneer, aluminum and steel parts with a moist cloth.
Milo is engineered for easy assembly. Carefully follow this
procedure to prevent any damage. Do not use power tools for
assembly of this product.
Step 1
Unpack and identify the parts listed below. The assembly
workspace should be a non-marring surface such as carpet.
For missing hardware pieces, contact BDI Customer Service at:
[email protected].
For all other concerns, please contact your BDI retailer.
Designed by Louis A Lara.
These distinctive product configurations are protected by US and international patents, trade dress, and/or
copyright laws. Milo & BDI are trademarks of Becker Designed, Inc. All rights reserved. ©2018, BDI
Patent: www.bdiusa.com/ip
Made in China. 02.11.2020 V2
T1 Hex Wrench x 1
A1 Mounting Plate x 1
A2 Post x 1
H1 Threaded Rods x 2
H1 Flathead Screws x 4
A3 Base x 1
C1 Top Panel x 1
Tool Included:
bdiusa.com
customerservic[email protected]om
MILOTM 1055/1065
MEDIA TABLE

bdiusa.com
customerservic[email protected]om
MILO 1055
MEDIA TABLE
2
Step 2 - Attach Mounting Plate to Top Panel
Place top panel C1 upside down on a non-marring surface. Position mounting plate A1 over the 4 threaded
holes with the stem towards the outside and attach with 4 flathead screws H1 using hex wrench T1.
T1
H1
A1
Threaded
holes
Overhead View
C1
Stem towards
edge

bdiusa.com
customerservic[email protected]om
MILO 1055
MEDIA TABLE
3
Step 3 - Attach Post and Base
Slide either end of the post 2A onto the stem of mounting plate A1. Place the stem of base A3 into the
opposite end of the post A2 and secure in place with 1 hand. With your other hand, slide 2 threaded rods H2
into the channels that run through post A2 and into the holes on the mounting plate A1. Tighten with hex
wrench T1.
T1
A1
H2 x 2
A2
A3
Stem