Berlin Gardens Bristol User manual

Bristol Swivel Chairs
Assembly Guide
Tools Required
Hardware Included
Cordless Drill #2 Square Drive Bit
Step 1
Fasten the back to the seat by fitting the
seat supports into the cutouts in the back legs.
Using the #2 square drive bit, drive
4 - 4" buglehead screws into the predrilled
holes in the back legs. You may need to reverse
your drill several times before being able
to pull the pieces tightly together.
Note: Ensure that the outside surfaces of the back leg
and seat support are even and are securely fastened
as noted below!
4 - 4" Buglehead Screws 4 - 1/4" X 3/4" Allen Head Bolts 4 - 1/4" Flange Nuts
Counter Bar XT
4" Buglehead Screws
Ensure that the outside surfaces of both pieces are even and are securely fastened!
Back & Seat Assembly Detail
Swivel
Allen Wrench
(included)
Wrench

Step 2
Fasten the swivel stem to the aluminum frame
located under the seat using 4 - 1/4" x 3/4"
allen head bolts and flange nuts.
Step 3
Lift the chair and set the swivel stem into the
receiver of the base. Push firmly onto the chair
until it sits securely in the receiver.
Swivel Attachment Detail
Step 4
Install the arms rests on your swivel chair using
the instructions and hardware provided with
the Arm Kit.
1/4"x 3/4" Allen Head Bolts
1/4" Flange Nut
DO NOT USE A SWIVEL CHAIR WITHOUT THE ARMS RESTS INSTALLED!