Berlin Gardens Mayhew Sling Counter User manual

Mayhew Sling
Counter & Bar Chairs
Assembly Guide
Tools Required
Hardware Included
Cordless Drill #2 Square Drive Bit
(Included)
5/32" Allen Drive Bit
(Included)
Step 1
2 - 3"
Buglehead
Screws
4 - 2"
Pandeck Screws
(Bar Height Only)
4 - 4"
Buglehead
Screws
8- 1/4" x 1 3/4"
Lags
Set the Arm and Seat Assembly forward onto the front of the
Arms and set the Back Assembly on top. Be sure to do this
on top of a soft surface to avoid damaging the arms.
Fasten the Back to the Seat using four - 4" Buglehead Screws.
Keeping the Arms Supports even with the outside edges of the
Back, fasten them using two - 3" Buglehead Screws.
4" Buglehead Screws
3" Buglehead Screws
Keep the Arm Supports even with the outside edge of the Back.
Arm & Seat Assembly
Back Assembly
Bar Height Counter Height

Step 2
(Bar Height Only)
Lay the chair on its side on a soft surface.
Set the tenons of the Back Leg Cross Piece into
the mortises located in the back legs.
Fasten using four - 2" Pandeck Screws.
Step 3
2" Pandeck Screws
Back Leg Cross Piece
Step 3 Detail
Place the Footrest Assembly between the chair legs.
Align the predrilled holes of the footrest with the predrilled
holes in the chair legs. Using the 5/32 Allen Drive Bit, fasten
it using 8 - 1/4" x 2" Lags
. You may need to reverse your drill
several times before you are able to drive the lags in completely.
1/4" x 1 3/4" Lags