Berlin Gardens Mayhew Chat Chair User manual

Mayhew Chat Chair
Assembly Guide
Tools Required
Hardware Included
Cordless Drill #2 Square Dri e Bit
(Included)
5/32" Allen Dri e Bit
(Included)
4 - 1" Buglehead Screws 8 - 2" Pandeck Screws 8 - 1/4" x 1 1/2" Lags
Step 1
Bottom View of Seat
Front of Seat Back of Seat
Narrower Space
between seat support
and end of seat.
Wider Space
between seat support
and end of seat.
Front of Seat
Detail B.
Detail C
Detail A.
A.
Put one of the side
assemblies on a soft
surface and place the
seat onto it by fitting the
mortis and tenons of the
two pieces togther.
(See Detail A.)
Use the example abo e
to ensure the front of the
seat is correctly located.
B.
Using the #2
Square Drive Bit,
begin attaching the
seat by riving 2 - 2"
Pan eck Screws
through the pocket
holes locate in the
very front an back
cross pieces of the
seat.
(See Detail B.)
C.
Finish attaching the seat to the
si e assembly by using the 5/32
Allen Drive Bit to rive 4 - 1/4" x 1 1/2"
Lags through the pre- rille holes.
in the si e of the seat.
You may nee to reverse your rill
several times before you are able to
rive the lag in completely.
2" Pan eck Screws
1/4" x 1 1/2" Lag

Back Attachment Detail
Step 2
Poly Tab at En of back Support Shoul Point Downwar s
1" Buglehea Screw
1" Buglehea Screw
1" Buglehea Screw
Fit the Back into place by
placing the poly tabs at the
ends of the back supports into
the cutouts in the back leg of
the side assembly. Fasten
using 1 - 1" Buglehead Screw
for each poly tab.
Step 3
1" Buglehea Screw
1" Buglehea Screw
2" Pan eck Screws
1/4" x 1 1/2" Lag
1/4" x 1 1/2" Lag
1/4" x 1 1/2" Lag
1/4" x 1 1/2" Lag
Attach the secon si e
assembly by repeating
Steps 1 & 2.