Berlin Gardens Garden Classic GCIT4472D Firmware update

#GCIT4472D, #GCIT4472C, #GCIT4472B
in Garden Classic Collection
PACKAGE CONTENTS
1Top
4 Bases
4 Long Cross Supports
2 Short Cross Supports
4 Footrests (Bar and Counter Height)
1 Umbrella Holder
1 Umbrella Plug
8 Braces
1 Hardware Package
TOOLS NEEDED:
Hammer
7/" Wrench
Cordless Drill/Screwdriver
Allen Wrench (Included)
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
Garden Classic Table
NOTE: Bar
and Counter
Height Only
Assembly Directions for
44"x72" Rectangular Table
Be sure to
use 1½"
screws when
fastening
braces.
!
Base
Long Cross Support
Short Cross Support
Upright
Top Boards
Apron
Brace
Umbrella
Holder
Curved End Board
Footrest
Garden Classic
Table
HARDWARE PACKAGE
16 ¼" x 2" Allen Head Bolts
16 ¼" Flange Nuts
2 Umbrella Knobs
44 3" Screws
8 1½ " Screws
16 5/8" Pan Head Screws
1 Allen Wrench

STEP #1 - First assemble both Bases and Long Cross
Supports using 3" Screws.
Please note: ere are two outside Bases and
two center Bases. e two center Bases have
extra mortises for the Umbrella Holder and
Short Cross Supports (see Step #3).
STEP #2 - Attach the rst Base Assembly to the
aluminum frame of the Top using
8- ¼" x 2" Allen Head Bolts.
STEP #3 - Attach the two Short Cross Supports and the
Umbrella Holder to the Base using 2½" Screws.
STEP #4 - First attach the second Base Assembly to the
aluminum Frame of the Top using 8- ¼" x 2"
Allen Head Bolts. Second fasten the Base
Assembly to the Short Cross Pieces and
Umbrella Holder using 2½" Screws.
STEP #5 - Last, attach the Braces to the Top and the
Base using 1½" Screws and 5/8" Pan Head
Screws (these go into the top).
Umbrella
Knobs
¼" x 2" Allen Head Bolts
3" Screws
2½" Screws
2½" Screws
¼" x 2" Allen Head Bolts
Footrest
1½" Screws
(circled)
Cross Support