Berlin Gardens Mathew Chat Counter User manual

Mayhew Chat
Dining Chairs
Assembly Guide
Tools Required
Hardware Included
Cordless Drill #2 Square Drive Bit
(Included)
5/32" Allen Drive Bit
(Included)
Step 1
Bottom View of Seat
Back of Seat Front of Seat
Narrower Space
between seat support
and end of seat.
Wider Space
between seat support
and end of seat.
Side View of Seat
Back of Seat Front of Seat
A.
Put one of the side
assemblies on a soft
surface and place the
seat onto it by fitting the
mortis and tenons of the
two pieces togther.
(See Detail A.)
Use the examples above to
ensure the front and back
of the seat are correctly
located.
C.
Using the #2
Square Drive Bit,
finish fastening the
seat by driving 2 - 2"
Pandeck Screws
through the pocket
holes located in the
very front and back
cross pieces of the
seat.
B.
Use the 5/32 Allen Drive Bit to
drive 4 - 1/4" x 1 1/2" Lags through
the pre-drilled holes in the side of the seat.
You may need to reverse your drill
several times before you are able to drive the
lags in completely.
4 - 1" Buglehead Screws 8 - 2" Pandeck Screws 8 - 1/4" x 1 1/2" Lags 8 - 1/4" x 2" Lags
(Not Included with Dining Ht.)
2" Pandeck Screws
1/4" x 1 1/2" Lag
Dining Counter Bar XT
Detail A
Detail B
Detail C

Step 2 Poly Tab at End of back Support Should Point Downwards
1" Buglehead Screw
1" Buglehead Screw
Fit the Back into place by
placing the poly tabs at the
ends of the back supports into
the cutouts in the back leg of
the side assembly. Fasten
using 1 - 1" Buglehead Screw
for each poly tab.
Back Attachment Detail
Step 3
Step 4
(Counter, Bar & XT Heights Only)
Attach the second side
assembly by repeating
Steps 1 & 2.
Footrest Attachment Detail
Place the Footrest Assembly between
the chair legs. Align the predrilled
holes of the footrest with the predrilled
holes in the chair legs.
Using the 5/32 Allen Drive Bit, fasten
it using 8 - 1/4" x 2" Lags
.
You may need to reverse your drill
several times before you are able to
drive the lag in completely.
1/4" x 2" Lags