Berlin Gardens GCDT0048D Firmware update

#GCDT0048D, #GCDT0048C, #GCDT0048B
HARDWARE PACKAGE
8 ¼" x 2" Allen Head Bolts
8 ¼" Flange Nuts
2 Umbrella Knobs
16 3" Screws
4 1½ " Screws
8 5/8" Pan Head Screws
1 Allen Wrench
PACKAGE CONTENTS
1Top
2 Bases
1 Cross Support
2 Footrests (Bar and Counter Heights)
4 Braces
1 Hardware Package
TOOLS NEEDED:
Hammer
7/" Wrench
Cordless Drill/Screwdriver
Allen Wrench (Included)
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
Garden Classic
Daisy Table
Umbrella
Holder
Cross Support
Base
Upright
Top Boards
Apron
Brace
Garden Classic
Footrest
Be sure to
use 1½"
screws when
fastening
braces.
!
NOTE: Bar and
Counter Height Only
Assembly Directions for
48" Round Table

Umbrella
Knobs
STEP #1 - Fasten the rst base to the aluminum frame
using 4- ¼" x 2" Allen Head bolts.
STEP #2 - First fasten the cross support to the base using
3" screws. Second fasten the two footrests to
the upright using 3" screws. (Counter and Bar
height only.)
STEP #3 - Fasten the second base to the aluminum frame
using 4- ¼" x 2" Allen Head bolts. Second
attach the cross support and footrest using 3"
screws.
STEP #4 - Last, attach the Braces to the Top and the
Base using 1½" Screws and 5/8" Pan Head
Screws (these go into the top).
Your 48" Round Table is complete!
¼" x 2" Allen Head Bolts
3" Screws
Cross Support
Footrest
¼" x 2" Allen Head Bolts
1½ " Screws (circled)
3" Screws