Better Bathrooms Windsor 550 Mirrored Cabinet User manual

0333 777 4777
Windsor 550 Mirrored Cabinet
0333 777 4777
with 1 Light
This instruction will cover installation of the following units
Codes:
7689
ClassIII approved product(output voltage 12V) does not need earth wire

Figure1
L N
+
L
+
-
*** The unit can only be installed by fully qualified electrician.
1. Position the mirror in a suitable location,make sure the domestic electrical mains
supply is within reach of the electrical entry point of the product.
2. Carefully mark the position of the mirror using a soft pencil ensuring it is level.
Remove the mirror and mark the mounting points. Please ensure that all marked
mounting points accurately match up with the fixing points on the mirror.
3. Using a suitable drill bit, drill holes in the marked positions to a suitable depth.
Installation Guide
* Use 6mm drill bit for hole

Page 3 Page 4
Installation Guide
5. Screw supplied fixings into wall plugs.
6. Ensure the domestic electrical mains supply to which the mirror is
being connected is turned off. Connect the domestic mains supply to
the wires on top of the mirror cabinet --- the live wire in brown and
4. Insert wall plugs level with the surface of the wall. If fitting to a tiled
surface, wall plugs should be inserted below the tile surface to avoid
cracking.
neutral wire in blue.
Product Specification
Parts List
7. Hang the cabinet onto the screws.