Bijur Delimon TM-5 User manual

BIJUR DELIMON INTERNATIONAL
[phone] LOCAL
[phone] TOLL-FREE
[phone] FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3 05/121
TM-5 Lubricator
Automatic Cyclic
Operation
Lubricator is a motor-driven piston pump spring discharge type. Pump cycle time is controlled by an
integral gear reduction in the motor. Lubricator can be actuated manually by raising and releasing
the instant feed button. Available cycle times are shown in the table below.
Cycle Time
50 Hz 60 Hz
6.4 min 5.3 min
10.6 min 8.8 min
32.0 min 27.7 min
64.0 min 53.5 min
128.0 min 107.0 min
Technical Data
Reservoir Capacity 1 liter (approximately 1 quart)
1 gallon
Lubricator Inlet Filter 40 micron particle separation
Discharge Pressure 60 psi maximum
Factory Discharge Setting 5cc
Discharge Volume Per Cycle* 2.5 to 5cc infinitely adjustable
Viscosity range 150 to 8,000 SSU at operating temperature
Notes Regarding Use
1. Lubricator inlet filter should be inspected periodically and cleaned/replaced as required.
2. Discharge pressure will decrease as discharge volume decreases, the number of meter units in
the system increases or oil viscosity decreases.
*Discharge Volume Per Cycle
To reduce oil delivery, remove lock screw, measure “A”, turn adjusting screw clockwise, increasing “A”
by “B” dimension, as shown on table below.
B Discharge
0.40” 2.5cc
0.32” 3.0cc
0.24” 3.5cc
0.16” 4.0cc
0.08” 4.5cc
0” 5.0cc
!
,OCKSCREW
!DJUSTINGSCREW

Note: Conversion kits for Crouzet motors
are available – request part #26600.

BIJUR DELIMON INTERNATIONAL
[phone] LOCAL
[phone] TOLL-FREE
[phone] FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3 05/122
Distribution System
Use Type F meter units. Maximum number of meter units permissible is 70. For system flow value (øT)
limitations, refer to table below.
Meter Units (#) Discharge Per Cycle (cc)
345
5700 800 800
10 550 680 750
15 440 520 650
20 360 460 520
25 320 400 450
30 275 325 390
40 210 245 290
50 155 185 220
60 110 135 160
Motor
Continuous duty, single phase, synchronous induction timing motor for 50/60 Hz, dual wound
for 115/230 VAC. Power consumption is 3 watts. Bijur reserves the right to change motor size,
mounting dimensions, and/or manufacturer.
Liquid Level Switch
Models of this lubricator equipped with liquid level switch are listed in the How to Order chart on
page 3. They are supplied so the switch will close an electrical circuit whenever the oil in the
reservoir is above the minimum operating level. Thus, when connected to a light or other indicating
device, the liquid level can be monitored.
Customers may reverse the operation when desired by inverting the float. When the float is reversed,
the switch will close an electrical circuit whenever the oil level is below the minimum operating level.
Note: Switch contact rating is 10 watts maximum (light or indicating device not supplied by
Bijur Delimon).
Motor Wiring Connections
115VAC Yellow & Red wires
(Insulate Black wire)
230VAC Yellow & Black wires
(Insulate Red wire)

BIJUR DELIMON INTERNATIONAL
[phone] LOCAL
[phone] TOLL-FREE
[phone] FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3 05/123
How To Order
Cycle Time TM-5 with 1 Liter Reservoir TM-5, Pump Only* Motor & Gear Box
w/ Level Switch No Level Switch w/ Level Switch No Level Switch
50 Hz 60 Hz Part # Part # Part # Part # Part #
6.4 min 5.3 min D2986 D2994 D3156 D3150 24278-3
10.6 min 8.8 min D2988 D2996 D3155 D3151 24278-1
32.0 min 27.7 min D2990 D2998 D3154 D3006 24278-2
64.0 min 53.5 min D3187 D3189 D3153 D3454 24278-4
128.0 min 107.0 min D2992 D3000 D3152 D3153 24278-5
When ordering, specify lubricator type and part number such as: TM-5 Lubricator, Part #D2994.
Service Parts
Order by part number and name show in table. Include complete lubricator part number and
serial letters as shown on nameplate. Example: S109 filter group for lubricator D3150, Serial NF. For
major repairs requiring parts not identified on the drawing, return the lubricator for factory
rebuilding and adjustment. If a new lubricator is required for replacement, order by part number
and serial letters shown on the nameplate.
Item Part # Description
1 HS195 Screw-cover Mounting
2 B9826 Motor Cover
3 B9834 Gasket Motor Cover
4 B3108 Thru Coupling
5 B8197 Reservoir Gasket
6 HS276 Screw
7 HW308 Lock Washer
8 HN234 Hex Nut
9 B9302 Reservoir Worm &
Gear Lubrication
10 B7301-51/2 Outlet Tube Assembly
11 B3815 Outlet Check Valve
12 B9558 Inlet Valve Assembly
13 B8561 Float Switch Assembly
14 B9311 Cam & Gear Assembly
15 HO402 O-ring
16 HW329 Retaining Ring
17 B9315 Rocker Arm Assembly
18 S109 Filter Group
19 B9475 Piston Assembly
20 B4705 Cylinder Only
21 B4715 Cylinder Nut
22 B9476 Operating Sleeve
23 B9308 Drive Shaft Assembly
24 B9230C Filler Cap (Plastic)
HF705C Filler Cap (Steel)
25 B8194 Instant Feed Button
26 S295 Piston/Pump Service Group
27 D3218 Replacement Reservoir
(not shown)
!
"
#
$
(

%
&
'
!
!$
=0<4?;0C4
<>C>A
;403B
<>C>A ;8@D83;4E4;BF8C27
!#
!
!"
!!
& %
$
#
"
!%
!
(
'
*Reservoirs are also available for
stand-alone lubricators:
1 gallon aluminum (part #D3295)
or
4 liter plastic (part #D3892).

BIJUR DELIMON INTERNATIONAL
[phone] LOCAL
[phone] TOLL-FREE
[phone] FAX
WWW.BIJURDELIMON.COM
2100 Gateway Centre Blvd., Suite 109
Morrisville, NC 27560
21836 • R3 05/124
Dimensional Schematics
TM-5 with 1 Liter Reservoir
TM-5, Pump Only
Measurements shown in inches.
(METAL RES: HS12 7
PLASTIC RES: HW312)