Breezesta PT-0603 User manual

REV06-2/2020
PIEDMONT BAR SWIVEL CHAIR
PT-0603
1 PT-0603 Assembly

A
B C
D
F
E
a
b c
d e
Suggested Tools:
Drill, Plastic Mallet, 1/2" Socket Wrench
G
H
IJ
f h
K
L
g i
PARTS
PART DESCRIPTION PART NO. QTY
A BASE SIDE ASSEMBLY SA-00231 2
B SWIVEL SUPPORT PRT-00411 2
C BASE SPREADER PRT-00410 2
D FOOTREST PRT-00428 1
E BOTTOM BASE SPREADER PRT-00425 2
F SEAT ASSEMBLY SA-00229 1
G LEFT ARM PRT-00417 1
H RIGHT ARM PRT-00418 1
I LEFT FRONT LEG PRT-00415 1
J RIGHT FRONT LEG PRT-00416 1
K FRONT RAIL PRT-00414 1
L BACK ASSEMBLY SA-00227 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a #8 X 1-1/2" TORX SCREW H-0000-S815 2
b #8 X 2-1/2" TORX SCREW H-0000-S825 13
c #8 X 3" TORX SCREW H-0000-S83 16
d 1/4"-10 X 3" LAG SCREW PAINTED H-0000-S103 4
e 1/4"-10 X 3" LAG SCREW UNPAINTED H-0000-S103 4
f 1" HEX BOLT 5/16" DIA H-0000-HB1 4
g DOUBLE SCREW H-0000-DS 2
h T20 & T25 TORX BIT H-0000-CTD 1
i PIEDMONT SWIVEL ASSEMBLY-GEN 3 H-0000-SA3 1
PT-0603 Assembly 2

T20
C
x2
c
x8
A
E
x2
T25
e
x4
i
T25
B
x2
d
x4
T20
b
x3
D
F
f
x4
1.
Attach Parts C & E to A using
Hardware c & repeat for the 2nd side
3.
While upside down press, or
hammer, Parts B into the grooves &
attach them using Hardware d
4.
Connect Hardware i using
Hardware e as shown
Please read entire instructions
before beginning
2.
Attach Part D with
Hardware b
5.
Attach Seat Assembly (Part F)
to the swivel brackets using the
hardware shown.
3 PT-0603 Assembly

T20
K
b
x2
H
J
g
b
x4
a
x2
b
x4
8.
Connect the previous assemblies to
Part K using Hardware b
10.
Attach Part L using the hardware shown
9.
Connect the assembly from Step 8 to
Part F using the hardware shown
Note:
Make sure Step 9 is
connected on the front of
Part F as shown Side View
7.
Repeat Step 5 for Parts G & I
6.
Connect Part H to J with Hardware g by
rotating Part H clockwise until the assembly is
tight
4 PT-0603 Assembly