Broyhill ANAHEIM 2879-61844P-23 User manual

MAINTENANCE:
WARNINGS:
GENERAL BEST PRACTICES FOR ASSEMBLY:
Regularly check hardware and tighten if necessary
2
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authori-
ty to operate the equipment.
CAN ICES-3(B) / NMB-3(B)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules and ICC. These limits are designed to provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Read all instructions before starting
Clear a flat covered space to being
Always best to do it with a friend
Note that hardware required is provided for every step
Pay attention to orientation
Letter of the part corresponds to a sticker on the product
Number of the hardware corresponds to its letter in the package
Helpful hints provided along the way
Cleaning Instructions:
1. Do not stand on the seat cushion.
2. For indoor use only.
3. Do not expose to direct sunlight.
4. Do not place this product near sources of excessive heat.
5. Avoid use of sharp objects on or near this product.
6. Use fabric/upholstery cleaner on spills and marks, as general household cleaners can damage fibres and discolour fabrics.
7. Clean spills/marks immediately, as stains are harder to remove when they are left unattended.
8. For persistent stains and overall cleaning, contact a professional upholstery cleaning company.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Do not allow children to play on or near this product.

PARTS LIST
3
X1
recliner power loveseat
(The legs of the recliner
power loveseat have been
assembled)
C
B
X1
chaise
X1
Back cushion
D
X1
Back cushion
X1
Back cushion
J
X10
Plastic legs with washers
(including the five legs of
the recliner power loveseat)
F
I
X1
Back cushion
H
X4
Pillows
G
X1
Back cushion
X1
Power cord
A
E

HELPFUL HINTS
• Separating parts before starting
Important: Remove the plastic caps
on the threaded bolts of each leg.
!
4
J
Important: Open the zipper on the
bottom of the chaise, then take
out the legs and power cord
out of the seat box.
!
BOTTOM B

Attach plastic legs with washers (J) to the bottom of the chaise (B) as shown. Close the zipper.
(Warning:The legs of the recliner power loveseat (A) have been assembled).
STEP 1
5
BOTTOM
A D
CORRECT BOTTOM VIEW INCORRECT BOTTOM VIEW
LEGS LEGS
B
J

STEP 2
6
a b
b
a
AB
There is a connection between recliner power loveseat (A) and chaise (B). Lift the recliner power
loveseat (A) on the open end where hooks are located and let the downward facing hooks (a) slide
into the upward facing hook slots (b) located on the chaise (B) as shown.

STEP 3
7
EFG
CD
H
A B
Attach the back cushions (C & D & E & F & G) to the back frame by zipper and clasps at the bottom
of the back cushions, put pillows (H) on the recliner power loveseat (A) and chaise (B) as shown.
H
H
H

OPERATING INSTRUCTIONS
8
FRONT
BACK
A
A
I
One end of the power cord (I) is connected to the recliner power loveseat (A), and the other end is
connected to the socket-outlet (100V-240V). When the power switch is pressed to the “—”, it means
it is on (power indicator light up), and when it is pressed to the “O”, it means it is off (power indicator
is off).
NOTE: The socket-outlet should be installed near the equipment and shall be easily accessible.

OPERATING INSTRUCTIONS
9
Open
Close
Open
Close
A
While seated, to make the footrest recline, press the “open” control button on the side of seat cushion.
To return the footrest to your desired position, press the “close” control button.

ASSEMBLED VIEW
10
The sectional is now ready for use.
PRINTED IN VIETNAM