Broyhill Heirlooms HN500S User manual

GENERAL BEST PRACTICES FOR ASSEMBLY:
WARNINGS:
MAINTENANCE:
* Please read the assembly instructions prior to assembling this product.
* Determine you have adequate space for assembly.
* Assembly by two adults is recommended.
* Assemble on soft surfaces to prevent damage to product finish.
* Keep children away during assembly. This item contains small parts which can be
swallowed by children.
* Do not discard any of the packaging until you have checked that you have all the
parts and hardware.
* Retain the assembly instructions for future reference.
* The manufacturer will not accept responsibility for unauthorized repairs or
modifications to this product.
* This product is for residential use only, not for commercial use.
* Should this product become damaged, and/or components are broken or missing,
DO NOT USE.
* The product will burn if left in contact with flame source.
* Wipe with a damp cloth. Use Furniture polish or lemon oil on the wood as
needed. Avoid prolonged exposure to moisture.
* Do not scratch or chip the finish.
* Do not put hot objects which are more than 80 degrees Fahrenheit directly on
the surface.
* Check bolts/screws periodically and tighten if necessary.
* To prolong the life of product we recommend storage in a dry area when not in
use or during austere weather conditions.
1

LONG BOLT x 8 pcs
Ø 14'' x 75 mm
SHORT BOLT x 6 pcs
Ø 14'' x 40 mm
SPRING WASHER
x 22 pcs
Ø 516'' x 13 mm
FLAT WASHER
x 22 pcs
Ø 516'' x 19 mm
MEDIUM BOLT x 8 pcs
Ø 14'' x 50 mm
ALLEN KEY
x 1 pc
Ø 4 mm
PARTS LIST
HARDWARE LIST
2
CHAIR BACK
x 2 pcs
SEAT BOX W/SEAT CUSHION
x 2 pcs FRONT LEG
x 4 pcs

STEP 1
x 4 x 7 x 7
HARDWARE NEEDED:
x 1x 3
Place the Chair Back (A) facing up on a soft smooth
surface. Attach the Seat Box W/Seat Cushion (B) to the
Chair Back (A) by inserting Flat Washer (4), Spring
Washer (3), Long Bolt (1) into the holes at the corner
block of the Seat Cushion (B). Attach the back of the
Seat Box W/Seat Cushion (B) to the Chair Back (A) by
inserting Flat Washer (4), Spring Washer (3), Short Bolt
(2) into the rear bar of the Seat Box W/Seat Cushion (B)
using Allen Key (6). Do not fully tighten bolts in this
step.
ASSEMBLED VIEW
TOP
BOTTOM
3

STEP 2
Attach the Front Leg (C) to the Seat Box W/Seat
Cushion (B) with Flat Washer (4), Spring Washer (3)
and Medium Bolt (5) using Allen Key (6). x 4 x 4 x 4
HARDWARE NEEDED:
TOP
BOTTOM
x 1
ASSEMBLED VIEW
4

STEP 3
HARDWARE NEEDED:
x 1
Carefully turn the assembled chair upright. Make sure the chair is level and fully tighten all
bolts at this time using Allen Key (6). Repeat steps 1 through 3 to assemble any remaining
chairs. Assembly is now complete.
TOP
BOTTOM
5
PRINTED IN VIETNAM