Buffalo Bain Marie 600 Series User manual

Model • Modèle • Modell • Modello • Modelo • Malli:
CU480
600 Series
Bain Marie
Instruction manual
CU480_EN_A5_v1_20231020.indb 1CU480_EN_A5_v1_20231020.indb 1 2023/10/20 13:332023/10/20 13:33

2
EN
Safety Instructions
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• DO NOT immerse the appliance in water, or use jet/pressure
washers to clean it.
• DO NOT touch hot surfaces with bare hands. Always use the
handles/protective gloves.
• DO NOT overfill the appliance. Keep the water level below the
‘MAX’ level.
• DO NOT allow the water level to drop below the ‘MIN’ level
during operation.
• DO NOT move the appliance when it contains hot liquid.
• DO NOT use the appliance for anything other than its intended
use.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a danger or injury.
CU480_EN_A5_v1_20231020.indb 2CU480_EN_A5_v1_20231020.indb 2 2023/10/20 13:332023/10/20 13:33

3
EN
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Warning: Opening the drain cock will lead to the outflow of
the hot contents of the Bain Marie.
• BUFFALO recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
• BUFFALO recommend that this product is connected to a circuit
protected by an appropriate RCD (Residual Current Device).
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Buffalo will not accept liability for product failures in the event that:
• The instructions in this manual have not been followed correctly.
• Unqualified or unauthorized personnel have adjusted the appliance.
• Non-original spare parts are used.
• The appliance has not been handled and cleaned correctly.
• The appliance has been used for a purpose for which it was not intended.
• The appliance is used by personnel not trained or unfamiliar with the usage of the unit.
Pack Contents
The following is included:
• BUFFALO Bain Marie • Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
CU480_EN_A5_v1_20231020.indb 3CU480_EN_A5_v1_20231020.indb 3 2023/10/20 13:332023/10/20 13:33

4
EN
Installation
The “bain marie” should be placed on a solid level surface. The on/off switch and thermostat should be
set to the off position.
Note: Before using for the first time, clean all parts well. Let dry completely.
Operation
Water tank
GN pan for food
Drainage tap
On/off switch
On/off switch indicator
Heating indicator
Thermostat
Reset switch Overheat indicator
1. Fill the tank with water to a level between the ‘MIN’ and ‘MAX’ marks on the inside of the tank.
Ensure the water level touches the bottom on the G/N pans being used.
2. Switch the on/off switch to the On position [I].
3. Set the thermostat to the desired temperature. The heating indicator will light up and the appliance
begins to heat the water.
4. When the set temperature is reached, the heating indicator turns off. (
During use, the heating
indicator will cycle on/off, indicating the set temperature is being maintained.)
5. Put the food into the GN pan then put the pan into the water tank.
6. After use, set the thermostat and on/off switch to “O” (OFF position) and disconnect the appliance
from power supply.
7. Allow to cool, then open the drainage tap to drain the water from the water tank.
WARNING: The food and water are very hot! Take care when removing the GN pan from the
bain marie.
CU480_EN_A5_v1_20231020.indb 4CU480_EN_A5_v1_20231020.indb 4 2023/10/20 13:332023/10/20 13:33

5
EN
Maintaining Water Levels
It is important to regularly check the water level in the tank.
• Always keep the water level above the ‘MIN’ mark on the inside of the tank during operation.
• Damage to the heating element can occur if the tank boils dry and the element may have to be
replaced. This is not covered by the BUFFALO warranty.
Thermal Cut-out Reset
The appliance is fitted with a Thermal Cut-Out safety switch. Should the temperature exceed safe levels
the appliance will automatically cut off power.
The thermal Cut-out switch is located on the front of the unit. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
WARNING:
Always turn off and disconnect the appliance from the power supply before cleaning.
Always allow the appliance to cool before emptying or cleaning.
• Wipe down the exterior of the appliance with a damp cloth.
• Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner. Daily cleaning is recommended.
• Wash all removable parts in warm, soapy water.
• Dry the exterior thoroughly.
De-scaling
To maintain energy efficiency and prolong the life of the appliance, regular de-scaling is needed.
• Pour a solution of neutral cleaner and water into the appliance.
• Brush gently with a soft brush.
• Discard the solution and flush out thoroughly with clean water to remove any solution residue.
• Wipe dry the appliance, especially the bottom part of the water tank.
Note: Use a suitable cleaner and always follow the instructions on the cleaner container.
BUFFALO recommend that this appliance is de-scaled every 3 months or more often in hard
water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
CU480_EN_A5_v1_20231020.indb 5CU480_EN_A5_v1_20231020.indb 5 2023/10/20 13:332023/10/20 13:33

6
EN
Troubleshooting
A qualified technician should carry out repairs if required.
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Fuse in the plug has blown Replace the fuse
Mains power supply fault Check mains power supply
Appliance does
not reach set
temperature, or
slow to heat up
Faulty thermostat Consult a qualified technician
Faulty heating element Consult a qualified technician
Appliance heats up
but indicator light
does not come on
Indicator light has expired Consult a qualified technician
On/off indicator
light comes on but
appliance does not
heat up
Faulty on/off switch Consult a qualified technician
Faulty heating element Consult a qualified technician
Thermostat set incorrectly Check thermostat
No power Thermal cut-out activated Please check your machine is safe with no
obvious damage and then press the re-set
switch
Appliance
overheats
Thermostat damaged Switch Off immediately. Consult a qualified
technician
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage Power Temperature
Range Capacity Dimensions H x W x D mm Weight
CU480 230V 1N~,
50-60Hz 1500W 30ºC - 90ºC GN 1/1 150mm 280 x 400 x 600 11.5kg
CU480_EN_A5_v1_20231020.indb 6CU480_EN_A5_v1_20231020.indb 6 2023/10/20 13:332023/10/20 13:33

7
EN
Electrical Wiring
This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply
with regulatory standards and specifications set by international,
independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserves the right to
change specifications without notice.
CU480_EN_A5_v1_20231020.indb 7CU480_EN_A5_v1_20231020.indb 7 2023/10/20 13:332023/10/20 13:33

CU480_EN_A5_v1_20231020.indb 8CU480_EN_A5_v1_20231020.indb 8 2023/10/20 13:332023/10/20 13:33

UK
[phone]
Eire
NL 040 – 2628080
FR 01 60 34 28 80
BE-NL 0800-29129
BE-FR 0800-29229
DE 0800 – 1860806
IT N/A
ES 901-100 133
CU480_EN_A5_v1_20231020.indb 9CU480_EN_A5_v1_20231020.indb 9 2023/10/20 13:332023/10/20 13:33

CU480_EN_A5_v1_20231020.indb 10CU480_EN_A5_v1_20231020.indb 10 2023/10/20 13:332023/10/20 13:33

CU480_EN_A5_v1_20231020.indb 11CU480_EN_A5_v1_20231020.indb 11 2023/10/20 13:332023/10/20 13:33

CU480_EN_A5_v1_2023/10/20
http://www.buffalo-appliances.com/
CU480_EN_A5_v1_20231020.indb 12CU480_EN_A5_v1_20231020.indb 12 2023/10/20 13:332023/10/20 13:33