CABINETS TO GO Findley & Myers WD2442 User manual

ASSEMBLY INSTRUCTIONS
These assembly instructions are only applicable for all Wall Diagonal Cabinets
ITEM# WD2442
Page 1

►Items Quantity
Item Description Qty
A
Left Front Side Panel 1
B
Right Front Side Panel 1
C
Frame & Door
1
D
1
E 1
F
Left Back Side Panel
1 Set
G
Hardware Box
2
Shelf Clips 12pcs, ST25mm Screw 4pcs, Metal 135° Brackets 4pcs, 1/2" Round Head Screws 8pcs, Bumper 2pcs, ST62mm Screws 8pcs, Wall Anchors 8pcs
► Required tools:
Page 2
►General Instructions:
Tools Required: Phillips Screwdriver Optional Tools: Electric Drill Optional Tools: Rubber Mallet
► Hardware Box:
a
bc
Qty 12 Qty 4Qty 4
ThankyouforpurchasingaCabinetsToGoproduct.Youarenowtheproudownerofahighqualityproductdesigned
tofacethetestofdaily useandguaranteeingyourenjoymentformanyyearstocome.
Carefullyreadtheinstructionsbeforestartingtheinstallation.
Duringassembly,pleasefollowallgenerallyacceptedsafetyprocedures.
FailuretoadheretothefollowinginstructionswillinvalidatethewarrantyandCabinetsToGowilldeclineany responsibilityforany
damagescaused.Anyinstallationwhichdoesnotcorrespondtotheinstructionsmayresultin defects,malfunctioningparts,significant
damageand/orinjury.
Beforetheassemblybegins,checkthatallappropriateandrequiredplumbingandelectricalconnectionsexist.
Beforedrilling,makeabsolutelysurethattherearenopipes(gas,water,electricity,heating,etc.)atthedrilling location.CabinetsToGowill
notbeheldresponsibleforfailuretofollowtheseinstructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT 1-800-
CABINET.
Top/Bottom Panels
The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;
therefore, your item may contain a smaller number of each.
Shelves
Back Panel
Right Back Side Panel
3
H
d e f
Qty 8 Qty 2Qty 8
g
Qty 8

G
G
A
B
F
1
2
SoftSurface
Hard Surface
F
F
Figure 2
Page 3
Figure 1
Assemble the Side Panels (B,A)
onto the Frame (F) by connecting
the male and female cam locks
and using a screwdriver to turn the
lock clockwise. (Figure 1)
{ NOTE: Assemble cabinet
parts on a flat smooth soft
work surface. }
Attach the top/bottom panels
(G) into the slots of the side
panels and lock the cam lock
connectors. (Figure 2)

H
H
H
a
3
4
Figure 3
Figure 4
Due to their size and shape, the shelves
will need to be installed before you
continue the cabinet's assembly.
Install the shelf clips (a) into the desired
locations of your choosing.
(Figure 3)
Page 4
Install the shelves (H) onto the
previously installed shelf clips.
(Figure 4)
a
Qty 6

E
D
C
a
5
6
Figure 5
Install the remaining shelf clips (a) onto
the back side panels (C,D), and attach
those panels as shown. (Figure 5)
Install the back panel (E) into the
position shown.
{ NOTE: You may need to gently spread
the back panels to seat the panel. }
(Figure 6)
a
Qty 6
Figure 6
Page 5

7
8
Figure 7
(Figure 8)
Figure 8
Page 6
Attach the back panel using
screws (b).
(Figure 7)
b
Qty 4
Install the metal brackets (c) using screws (d)
to the frame and side panels at the top and
bottom of the assembled cabinet.
c
Qty 4
d
Qty 8

e
►Maintenance
For daily cleaning, use a dry cloth and a soft liquid cleaner.
Never use abrasive cleaners containing acetone, chlorine or strong bleach. Also, do not use tools as scrapers,
metallic brushes, and other products which can scratch or tarnish surfaces.
Under no circumstances should you use chrome cleaner on chrome-plated or brass trim, hinges, handles, sockets
etc.
Good ventilation is essential for maintaining the quality and look of this furniture.
Warranty and Customer Care Information
For the most up to date warranty information for your product, please visit our website - www.cabinetstogo.com to
get the specific details. If you have any questions with warranties or to make a claim, please contact Customer Care
by email - [email protected] or call 1-800-CABINET.
Page 7
9Install the bumpers (e) onto the door at
the corners where the door comes in
contact with the frame.
(Figure 9)
Figure 9