Canon Paper Craft Castel Sant'Angelo Italy User manual

http://www.canon.com/c-park/en/
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions : Eleven A4 sheets (No. 1 to No. 11)
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
* This model was designed for Papercraft and may differ from the original in some respects.
Before starting assembly :
Writing the number of each section on its back side before
cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after
cutting out the sections.)
Indicates where sections should
be glued together.
Glue the rear sides together.
Glue the rear sides together.
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Glue the rear sides together.
Glue the rear sides together.
Glue the rear sides together.
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Insert one end into
the other and glue
these ends together.
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Glue the rear
sides together.
Take care to ensure
this piece faces in
the correct direction.
Glue the rear
sides together.
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Glue the rear
sides together.
Glue the rear
sides together.
Position the glue spots
on the outside.
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama

Glue the rear sides
together.
Top
Bottom
Castel Sant'Angelo, Italy : Assembly Instructions ©Canon Inc. ©T. Ichiyama