CARLO GAVAZZI ROG400 User manual

CARLO GAVAZZI
Automation Components
Carlo Gavazzi Controls SpA,
Via Safforze, 8 - 32100
Belluno (Italy)
Tel. [phone],
Fax [phone]
ROG400 RoHS
Instruction manual
ROG400 IM ITA
19028
cod. 8020852
NO!
Positioning of the sensor relative to the conductor
In order to achieve the rated measurement
precision, the sensor must be positioned
as shown in the figure on the left, where the
two longitudinal axes (of the conductor and
of the sensor) are aligned.
In order to achieve the rated measurement
precision, the minimum diameter of the
conductor must be 25mm.
It is mandatory to fasten the sensor to the
power conductor by means of a suitable
clamp (required width 6mm, or by means of
2smaller clamps) as shown on the drawing
on the left.
YES
In order to avoid a measurement
error higher than the rated one,
the sensor must never exceed a
+/- 5° inclination angle relative to
the conductor, as shown in the
figures on the left and on the right.
Technical specifications of sensor ROG400
Sensor dimensions
18cm.
• Max cable diameter to which the sensor can be
adapted: 4,0cm.
• The sensor must be fastened to the primary cable
by means of two tabs.
• Length of the connection cable (sensor-instru-
ment: 3m.
• Code sensor: ROG400.
• Measuring range: from 0AAC to 400AAC (50Hz).
• Generated signal: from 4mADC to 20mADC.
• Min: 4mADC = 0AAC (50Hz).
• Max: 20mADC = 400AAC (50Hz).
• Accuracy 1,0% F.S. (in the range from 0% F.S. to
100% F.S.).
• Circumference of the sensitive part of the sensor:
Sensor opening/closing and electric connection to the WM14
29mm
Diameter 7mm
max. 5°
max. 5°
max. 5°
max. 5°
17mm
54mm
Diameter 5mm
If it is necessary to remove the sensor, operate with care, following the drawing, with a suita-
ble screwdriver so as to enlarge the seat of the sensor and easily remove it.
VP RED
S+ WHITE GND BLUE
VP RED
S+ WHITE
GND BLUE
VP RED
S+ WHITE
GND BLUE
VP RED
S+ WHITE GND BLUE

NOTES ABOUT THE CONNECTIONS
ROG400 (new 3-wiremodel) WM14DINA204HR2X1 (new version) ROG400 (new 3-wiremodel) WM14DINA204HR2XX (former version)
ROG400 (former 4-wiremodel) WM14DINA204HR2X1 (new version)
ROG400 (former 4-wiremodel) WM14DINA204HR2XX (former version)
VP (red wire)
S+ (white wire)
GND (blue wire)
VP (red wire)
S+ (white wire)
GND (blue wire)
VP
S+
GND
VP
-
GND
+
VP
S+
GND
VP
-
GND
+
VP (red wire)
+(orange wire)
GND (black wire)
-(brown wire)
VP (red wire)
+(orange wire)
GND (black wire)
-(brown wire)