Celexon Manual Economy User manual

User Manual
celexon Manual Economy
Thank you for purchasing this product.
For optimum performance and safety, please read these instructions carefully
before connecting or operating this product. Please retain these instructions for future
reference.
Version: 32422_031

1
The purpose of these operating instructions is to familiarise you with the
operation of this this product. Therefore, keep these instructions in a safe place
so that you can refer to it at any time.
• Before installation, please refer to the enclosed data sheet for further
safety and use instructions.
• Do not begin installation until you have fully read and understood the
complete operating instructions.
• This product should only be installed by qualied personnel with
mechanical and electrical knowledge.
• Carry out the installation with another person to ensure safe installation.
• Remove the product from its packaging and remove all packaging mate-
rials.
• Make sure that no packaging material is on or in the product. If you notice
any damage to the packaging, also check for damage to the product.
• If you notice any external damage to the appliance or any unexpected or
unusual functioning, do not use the product further. Immediately contact
the dealer from whom youyou purchased the product or celexon directly
(Web: www.celexon.co.uk, Mail: [e-mail]) for further information.
To ensure trouble-free operation, the product may only be used indoors. It
is NOT suitable for outdoor use.
• The use of the appliance and accessories is forbidden to children under 16
years of age.
• Ensure that no children play with the appliance or are in the vicinity
without supervision.
• Modifying or altering the product may compromise product safety.
• Caution: Risk of injury! Never open the product yourself unauthorised.
Never carry out repairs yourself!
• This product can only be used under the standard technical parameters.
• Do not use the product near corrosive gas, water or in a dusty
environment.
• Handle the product with care. It can be damaged by knocks, blows or
drops from even a small height.
• Keep the product away from moisture and heat. Never immerse the
product in water or other liquids.
• Use the product only in the manner for which it is intended. Use for any
WARNINGS

2
other purpose may result in damage to the product or its surroundings.
• Carry out the installation with another person to ensure safe installation
Technische Änderungen und Irrtümer vorbehalten.
• Tighten the screws, but do not overtighten them. Overtightening (e.g.tigh-
tening using a cordless screwdriver) can cause damage and impair the
secure hold of the screen.
• Suspended loads must be checked at least twice a year for strength and
load-bearing capacity at least twice a year.
• Children should not use the screen or play under it unsupervised.
• Failure to follow the above instructions may result in personal injury and
damage to the product or equipment. Incorrect installation or use may also
invalidate the warranty
• If you are unsure about the use of the product, please contact your
• specialist personnel, your dealer or celexon directly
(Web: www.celexon.co.uk, Mail: [e-mail])
• Technical changes and errors expected.
The manufacturer accepts no responsibility for damage to property or perso-
nal injury if the screen is used outside the recommended specications or for
improper installation. Do not use this screen near heaters or air conditioners.
Also do not mount product in direct sunlight or in front of a window. Due to the
temperature-sensitive PVC surface, the projection screen may be permanently
damaged.
We recommend that you wait approx. 2 hours after delivery before installing
the projection screen.This allows the projection screen to acclimatise, especial-
ly if the screen is moved from a cold to a warm environment.
Please avoid any stains on the surface of the fabric. These may not be able to
be removed.

3
DISCLAIMER
The information in this document is subject to change without notice by the
manufacturer. Changes will be added to subsequent versions of this manual.
The manufacturer does not guarantee or warrant for the correctness of the
information in this document.
CARE INSTRUCTIONS
NEVER clean the screen with alcohol or other cleaning agents that contain sol-
vents. Use only a soft and clean cloth. A mild soap solution (max 5%) may be
used to remove dirt from the surface. Avoid contact with sharp or pointed ob-
jects as these could permanently damage the projection screen fabric. Further
instructions can be found in the enclosed projection screen instructions.

4
INSTALLATION NOTES
Install the screen in a position that is fully visible to all viewers! The optimum
installation height corresponds to the position of the viewers in the centre of
the screen with the screen fabric extended: eye level = lower third of the screen
surface.
The screen can be installed on the wall/ceiling or hung from the ceiling on
hooks (the eyelets are already on the side cap). For wall or ceiling installation
only, the eyelets should be removed in advance). Please make sure that the me-
tal shims are also used for wall and ceiling mounting, otherwise safe installation
cannot be guaranteed).
The enclosed installation material is intended for a solid stone wall. If neces-
sary, obtain suitable mounting material for your installation surface.
Attach the eyelets to the two side caps and measure the distance between
them.Mark the points on the ceiling and make sure that the eyelets are aligned
with each other and parallel to the wall. Pre-drill the holes at the markings with
the right diameter drill bit for the hooks and mounting material, x them to the
ceiling and hang the screen.
CEILING MOUNTING (VIA EYELETS)
IN THE BOX
1x Screen
4x washers
4x Plastic dowel
4x Nuts
4 x Screws 4 x Ceiling loops

5
MOUNTING ON THE CEILING (SCREWED)
Measure the distance between the ho-
les in the side caps (two per cap) and
transfer them to the ceiling. Drill the
holes at the markings with the right
diameter drillbit for the diameter of the
mounting material, insert and screw
the screen in place tightly. Make sure
that the holes are parallel to the wall!
Use dowels and screws suitable for
your mounting surface.
Caution: Do not overtighten the
screws! If you notice cracks in the caps
they must be replaced! The screen
must not be used with cracked caps.
Please ensure that the metal plates are
also used for wall and ceiling mounting,
otherwise a safe installation cannot be
guaranteed).

6
Measure the distance between the ho-
les in the side caps (two per cap) and
transfer them to the wall.
MOUNTING ON THE WALL
Drill the holes at the markings with the
holes with the right diameter for the
mounting material and make sure that
the drill holes are absolutely level (Use
a spirit level!).
Use dowels and screws that are suitab-
le for your mounting surface. Screw the
two upper screws into the wall most
of the way and hang the screen from
both sides into the upper hole. Make
sure that the screen is installed straight
and level. Tighten the screws and then
tighten the lower screws on both sides
of the screen.
Caution: Do not overtighten the
screws! If you notice cracks in the caps
they must be replaced! The screen
must not be used with cracked caps.
Please ensure that the metal shims are
also used for wall and ceiling mounting,
otherwise a safe installation cannot be
guaranteed).

7
OPERATION
Pull the fabric by the handle of the
weighted bar to the desired position
(Fig. 1). Wait 1-2 seconds and slowly
release the handle until the screen
locks. The screen can be locked at
multiple lengths.
Pull the fabric down a few centime-
tres quickly so that the mechanism is
unlocked (Fig. 2).
When the lock is released, you will feel
a slight retraction. Move the screen ver-
tically upwards at an even speed. Do
not allow the screen to retract upwards
without being guided, otherwise the
bar will enter the housing at great
speed and the abrupt force can
damage the screen and side caps.
The screen could fall down and injure
people! Please note: Never pull the
screen all the way to the end, as it can
then no longer be retracted.
Look out for the stop sticker at the
top of the screen fabric and do not go
beyond it.
STEP 2: RETRACT THE SCREEN
STEP 1: PULL DOWN THE SCREEN
celexon Europe GmbH | Gutenbergstraße 2 | 48282 Emsdetten | DE