Cerio DT-300N V2 User manual

CERIO Corporation
DT-300N V2
eXtreme Power 11n 2.4Ghz 2x2 Wireless Access
Point (1000mW)
Quick Start Guide

Table of Contents
1. Product Outward Appearance .......................................................................................................3
2. Panel Function Description............................................................................................................3
3. Mounting Installation .....................................................................................................................4
4. Installation for Mounting kit...........................................................................................................5
5. Software Configuration ...................................................................................................................5

1. Product Outward Appearance
2. Panel Function Description
(1) The Ethernet connect of ETH2 Port
(2) The LED indicator of ETH2 Port
(3) Reset button
(4) The Ethernet connect of ETH1 / PoE Port
(5) The LED indicator of ETH1 Port
(6) Power LED
(7) Ground connection
Product Front Product
Bottom
Product
Side

(8) When use Client Bridge + Repeater AP and WISP + Repeater AP modes the 3 LED’s is represent
bridge signal for strong or weakly indicator.
3. Mounting Installation
Install Ethernet Cable
Install Grounding Cable

4. Installation for Mounting kit
5. Software Configuration
Example of Segment: (Windows 7)
IP Segment Set-up for Administrator's PC/NB
Set the IP segment of the administrator's computer to be in the same range as DT-300N v2 for accessing
the system. Do not duplicate the IP Address used here with IP Address of DT-300N v2 or any other device
within the network.

Step 1 :
Please click on the computer icon in the bottom right window, and click “Open Network and Sharing
Center”
Step 2 :
In the Network and Sharing Center page, Please click on the left side of “Change adapter setting”
button

Step 3 :
In “Change adapter setting” Page. Please find Local LAN and Click the right button on the mouse and
Click “Properties”
Step 4 :
In “Properties” page, please Click “Properties” button to TCP/IP setting

Step 5 :
In Properties page to setting IP address, please find “Internet Protocol Version 4 (TCP/IPv4)” and
double click or click “Install”button.
Step 6 :
Select “Use the following IP address”, and fix in IP Address : 192.168.2.#
ex. The # is any number by 1 to 253
Subnet mask : 255.255.255.0
And Click "OK" to complete the fixed computer IP setting
Double click
Or click Install button

Step 6 :
Open Web Browser
Launch as web browser to access the web management interface of system by entering the default IP
Address, http://192.168.2.254, in the URL field, and then press Enter. Browser will pop up "login" page.
Please key in username and password into the system on DT-300N v2.
The system manager Login Page then appears.
Enter “root” as User name and “default” as Password, and then click “OK” to login to the system.
Login information
DT-300N software functions for details, refer to the user's manual
By CenOS5.0 Software Router AP/ AP / WDS/Client Bridge + Repeater AP/ WISP+
Repeater AP mode
Default IP Address
192.168.2.254
Account root
Password
default