Childcare Calmo User manual

IMPORTANT:
RETAIN FOR FUTURE REFERENCE,
READ CAREFULLY
Calmo
Rocker“ Trios”
Model # 031832-389

Read all instructions before assembly and use of the rocker. Keep
instructions for future use.
SAFETY PRECAUTIONS
Rocker age range suitability:0 - 6 months
Toddler Seat age suitability:6 - 36 months
Weight limit:18kgs.
Remove packaging from rocker vicinity after it is assembled.
Ensure your child is secured with the correctly adjusted safety harness.
Keep medication,strings,elastics,and small toys (other than the ones attached to the toy mobile) out of reach from any position of
the rocker.
Ensure that proper ventilation is maintained in and around the rocker by limiting bed clothes,extra pillows or toys.
Be aware that ribbons or lace associated with bedding that may entangle the infant.
Ensure child is not positioned face down in the rocker.
When adjusting from rocking mode to stationary mode or vice versa,ensure the desired position is locked in place again after any
adjustment.
The soft toys are not intended to be“mouthed” by the baby and should be positioned clearly out of reach of the baby’s face and
mouth.
Adjust the toy mobile to avoid being too close to the baby.
The rocker is designed for use by one baby only.
Make sure all the locking equipment is installed well before using the rocker.
DO NOT use the rocker on an rough surface to avoid any injury to the infant.
DISCONTINUE USE of rocker when infant attempts to climb out.
DISCONTINUE USE of rocker when infant can roll over.
NEVER use the toy-bar to carry the rocker.
This rocker DOES NOT replace a cot or a bed.Should your child need to sleep,then it should be placed in a suitable cot or bed.
DO NOT use accessories or replacement parts other than those approved by the manufacturer.
BEFORE ASSEMBLINGTHIS ROCKER,READ AND UNDERSTANDTHE INSTRUCTIONS.
Never leave the child unattended.
Never use this product on an elevated surface,eg. A table.
This reclined rocker is not intended for prolonged periods of sleeping.
Always use the restraint system.
Do not use the reclined rocker once your child can sit unaided (approximately birth until
18kgs).
To avoid injury ensure that children are kept away when unfolding and folding this product.
Do not let children play with this product.
Do not move or lift this product with the baby inside it.
Never use the toy bar to carry the reclined rocker.
Do not use if any components are broken or missing.
KEEP INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
WARNING

Due to variations in the style and design of our products, the photographs and illustrations shown in this
instruction manual are generic,therefore product fabrics,colour and design may vary from images shown.
CNP Brands reserves the right to alter product specications without notice as a result of our ongoing
policy of product improvement.
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Calmo Rocker
Congratulations on yourpurchaseoftheCalmo Rocker
“Trios”
This product has been designed and developed with safety,
comfort and functionality in mind. Please take the time to read
this manual carefully before using this product and keep it in a
safe place for future reference.
CONGRATULATIONS

ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the
box against the list below. If anything is missing, please contact
Customer Service.
InAustralia,contact CNP Brands on 1300 667 137,in New Zealand
contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
Rocker Frame
and Liner
Assembly
x 1
x 1
x 1
Toy Bar with Toys
Hood
Awaiting new
sample for image
There are no accessories recommended for use with this Childcare Rocker.

ASSEMBLY / OPERATING INSTRUCTIONS
To assemble Rocker frame...
The rocker is now ready for use.
To assemble and operate Hood...
To assemble Toy Bar...
1
1
2
1
Pull the Rocker Frame and Liner Assembly
upwards until the rocker opens and clicks into
place.
Secure back of hood over top of chair with
fabric pocket.
Clip plastic clips of hood on both sides of the
metal frame.
To open the canopy, pull forward.
To close the canopy,pull back.
Clip the Toy Bar onto the side arms.
1a.
1a.
1b.
2a.
2b.
1a.
NOTE: Never attempt to lift the rocker by using the toy bar.
Awaiting new sample
for image

ASSEMBLY / OPERATING INSTRUCTIONS
To operate Stationary Position...
To operate Swinging Position...
To adjust the Backrest...
1
2
To adjust the back rest inclination,operate the
lever on the back rest and position it in the
desired position.
The back rest can be set to 3 positions.
1a.
2a.
1
1
To x the position of the baby rocker, fold both
feet downwards.
In order to bring the baby rocker into swinging
position,fold both feet on the metal frame
upwards and put the back rest into sitting
position.
1a.
1a.

1
2
5
3
4
Always make sure to fasten the harness and secure
your child when using the baby rocker.
To close the seatbelt,insert both side parts
of the seatbelt into the buckle centre until it
audibly engages with a“clicking sound”.
To release shoulder straps,squeeze and pull
through top of waist harness,see image
opposite.
Make sure that the tension is correct and the
seatbelt fastening is proper.
Adjust the seatbelt length.
To release the seatbelt, press the button on the top
of the buckle,thereby the seatbelt side parts open
automatically and you can pull your child from the
seatbelt.
1a.
2a.
5a.
3a.
3b.
4a.
ASSEMBLY / OPERATING INSTRUCTIONS
To operate 5 Point Harness...

ASSEMBLY / OPERATING INSTRUCTIONS
To convert to Seat Mode...
Awaiting new sample
for image
2
1
2
Feed crotch cover through corresponding hole in
bottom lining and under seat strengthening board.
Hold both the lever on the back rest and the
knob on the frame side down.
Fold the back rest to the front until the
seat is entirely folded.
2a.
1a.
2a.
1Feed harness straps through corresponding holes in
lining.
1a.
To fold Rocker continued...
Awaiting new sample
for image

To remove Seat Cover...
To replace Seat Cover...
2
3
Open the zip at the foot of the seat.
Pull the cover carefully over the back rest.
2a.
3a.
1
1
Remove the toy bar and hood.
The cover can be removed from the rocker for
cleaning purposes.Bring the rocker into the
topmost position.
Remove the seat strengthener by opening the
zip at the underside of the seat and remove
the wooden strengthener.
To put the cover back on the rocker,connect
the cover with the lower half of the frame by
closing the zip.
1a.
1b.
1c.
1a.
ASSEMBLY / OPERATING INSTRUCTIONS
CAUTION: The cover must not be cleaned with chemicals.
Observe the care and cleaning instructions in this manual.

ASSEMBLY / OPERATING INSTRUCTIONS
To replace Seat Cover continued...
2
2
3
In order to pull the cover above the back rest, you
must bring the back rest in a 45° position.
To do that,hold both the lever on the back rest and
the knob on the frame side down and fold the rest to
the front into the corresponding position.
Pull the cover above the back rest over the adjusting
lever.
Fold the back rest back until it clicks into place and
the cover is taut.
Re-insert the seat strengthener into the opening
at the back of the seat and close the zip.
2a.
2b.
2c.
2a.
3a.