Childcare Twin Tour User manual

IMPORTANT:
RETAIN FOR FUTURE REFERENCE,
READ CAREFULLY
Twin Tour
Stroller “Shadow”
Model #019111-387

2
Read all instructions before assembly and use of the stroller. Keep
instructions for future use.
SAFETY PRECAUTIONS
TO AVOID INJURY OR DEATH:
FOLLOWTHE MANUFACTURER’S INSTRUCTIONS.
ALWAYS APPLYTHE BRAKES WHENEVERTHE STROLLER IS STATIONARY.
USETHETETHER STRAP AT ALLTIMESTO PREVENTTHE STROLLER ROLLING AWAY.
DO NOT LEAVE CHILDREN UNATTENDED.
SECURETHE CHILD INTHE HARNESS AT ALL TIMES.
DO NOT CARRY EXTRA CHILDREN OR BAGS ONTHIS STROLLER.
MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUSTTHE STROLLER,
OTHERWISETHEY MAY BE INJURED.
TO AVOID INJURY ENSURE THATYOUR CHILD IS KEPT AWAY WHEN FOLDING AND
UNFOLDINGTHE STROLLER.
ENSURETHAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE.
WARNING
Check that all safety locks are engaged before placing a child in the stroller.
Ensure your child is secured with a correctly adjusted safety harness.
DO NOT allow children to stand on the seat.
DO NOT hang bags or goods from the handle as this could cause the stroller to tip over.
DO NOT place more than 5kgs in shopping basket.
The weight of the child should not exceed 20kgs (each seat).
The height of the child using the stroller should not exceed 96cm.
Only use accessories recommended by manufacturer.Using non-approved accessories may be unsafe.
NEVER ride with more than two children in the stroller.
It is recommended not to use stroller on escalators and stairs for safety reasons while child is in it.
This stroller is designed for use on at or gently slopped surfaces and may become unstable (tipping over) on uneven surfaces
and slopes of moderate to high elevation.
Always use safety locks.
Promptly replace worn out or broken parts.
Remove the child from the stroller before going up or down stairs and escalators.
DO NOT lift the stroller by the front bumper bar or tray (if supplied).
To prevent the risk of the stroller catching re,do not park it near an open re,heater or barbecue.
For warranty purposes,keep your sales receipt to provide proof of purchase.
DO NOT make any changes or alterations to this product,unless through an approved service agent.
To avoid the risk of suffocation, keep all plastic packaging materials out of reach of children.
NEVER leave safety harness connected when not tted to a child in the stroller as this may create loops that could cause a
strangulation hazard.
When seat is in the fully reclined position,the canopy must be attached and fully secured at the back of the seat frame,as this
forms a safety head barrier at the top of the seat.
Ensure the storage latch is fully engaged when lifting or carrying the stroller.

3
Due to variations in the style and design of our products, the photographs and illustrations shown in this
instruction manual are generic,therefore product fabrics,colour and design may vary from images shown.
CNP Brands reserves the right to alter product specications without notice as a result of our ongoing
policy of product improvement.
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Twin Tour Stroller
Congratulations on your purchase of the Twin Tour
Stroller.
This product has been designed and developed with safety,
comfort and functionality in mind. Please take the time to read
this manual carefully before using this product and keep it in a
safe place for future reference.
CONGRATULATIONS

4
ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the
box against the list below. If anything is missing, please contact
Customer Service.
InAustralia,contact CNP Brands on 1300 667 137,in New Zealand
contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
There are no accessories recommended for use with this Childcare Twin Tour Stroller.
Bumper bar x 2
x 2
x 2 x 2
x 1
x 4
x 2
x 2
Front Dual Swivel
Wheels
Stroller Frame
(Pre-Assembled)
• Five Point Safety Harness
• Storage Basket
• Shoulder Pads
• Hood
• Seats
Rear Wheels

5
ASSEMBLY / OPERATING INSTRUCTIONS
To unfold Stroller...
To attach Front Swivel Wheels...
1
1
2
2
Release the folding lock as shown in image.
Insert the wheel onto the front wheel axle on the
stroller frame until it‘clicks’into position.
Pull the wheel downwards to make sure it is securely
attached before using stroller.
Repeat for other Front Swivel Wheel.
Lift handle and seat apart until the frame
‘clicks’and locks on both sides.
Ensure stroller is locked on both sides before
continuing.
1a.
1a.
2a.
2b.
2a.
2b.
ENSURE CHILDREN STAY CLEAR WHEN UNFOLDING/FOLDINGTHE STROLLER.
WARNING

6
ASSEMBLY / OPERATING INSTRUCTIONS
To operate Swivel Function...
1
2
To lock swivel wheels,slide lever up until it ’clicks’.
Repeat for other Front Swivel Wheel.
To unlock swivel wheels,push lever down until it
‘clicks’.
Repeat for other Front Swivel Wheel.
1a.
1b.
2a.
2b.
To remove Front Swivel Wheels...
1
2
Press button on the front of the wheel housing.
Pull the wheel downwards to release from
housing.
Repeat for other Front Swivel Wheel.
1a.
1b.
2a.
CAUTION! Always unlock the swivel function before folding the stroller.

7
ASSEMBLY / OPERATING INSTRUCTIONS
To attach Rear Wheels...
To use Rear Brake...
1
2
To lock rear wheels,push down on the red
brake pedal on the rear axle with your foot.
To unlock rear wheels,lift the red brake pedal
with your foot.
1a.
2a.
1
2
Lift the rear of the stroller slightly upwards.
Insert the rear wheel axle into the housing until
it clicks into place.
Pull wheel outwards to check it is secure.
Repeat for other Rear Wheel.
1a.
1b.
2a.
2b.
CAUTION! Always apply rear brake when parking stroller.

8
ASSEMBLY / OPERATING INSTRUCTIONS
To adjust Canopy...
1To open,pull canopy forward until extended.
1a.
To adjust Backrest...
1
2
To lower the backrest,squeeze adjuster and
pull down to lower backrest to the desired
position.
To raise the backrest,squeeze adjuster and
pull the straps outward to raise backrest to the
desired position.
Release adjuster and check that the backrest
is secure.
1a.
2a.
2b.

9
ASSEMBLY / OPERATING INSTRUCTIONS
2To close,push canopy back.
2a.
CAUTION! The canopy must be fully closed before folding the
stroller.
To adjust Viewing Window...
1
2
To open,lift viewing window ap forward.
To close,lower back into place and ap will secure
with magnets.
1a.
2a.
To use Tether Strap...
1Ensure tether strap is used at all times.
Make sure your hand is fed through the loop as
shown to the right.
1a.
To adjust Canopy continued...

10
ASSEMBLY / OPERATING INSTRUCTIONS
Restraints - Harness...
1
2
3
4
5
To secure the child in the harness,place
left hand buckle prong (b) on top of (a).
Hold both left hand buckle prongs (a)
and (b) together and insert it into buckle
housing (e) until it snaps into position.
Repeat previous steps for right hand
buckle prongs (c) and (d).
Once all attached,carefully adjust the
harness straps by pulling each slider (f)
until the desired t is achieved in the lap,
shoulder and crotch straps.
To release the buckles,squeeze the top
and bottom prongs (a) and (b),(c) and
(d) together until harness disengages.
(a),(b): Left hand buckle prongs
(c),(d): Right hand buckle prongs
(e): Buckle housing
(f): Strap adjustment sliders
CAUTION: Always adjust the harness when changing the seating position of the child.
a
ff
ff
f
c
e
b d
USETHIS HARNESS AT ALLTIMES
WARNING

11
ASSEMBLY / OPERATING INSTRUCTIONS
To attach Bumper Bar...
1
2
To attach the bumper bar,gently insert the
bumper into the slots until they click into
position.
To remove, push release button on the outside
of the mountings and pull bar outwards.
1a.
2a.
To adjust Waist Strap...
1To loosen waist strap,push up both top and bottom
straps through buckle as circled in diagram.
To place waist strap in desired position,slide the
bottom strap into position then pull the top strap and
tighten into position.
1a.
To adjust Footrest...
1Lift the footrest up until it locks into place.
Make sure to lift the footrest higher than locking
mechanism.
1a.
1b.
Top strap
Bottom
strap

12
ASSEMBLY / OPERATING INSTRUCTIONS
To adjust Footrest continued...
2
3
To lower the footrest,press both levers located
at the pivot point of the footrest as shown.
Push footrest down to sit against the seat pad.
2a.
3a.
To fold Stroller...
1
2
Ensure both of the canopies are closed.
Return both seats to the fully upright position.
Ensure both footrests are in the lowest position.
Slide the primary lock button on top of
the handle to the left,while squeezing the
secondary lock button located underneath
the handle.
1a.
1b.
1c.
2a.

13
ASSEMBLY / OPERATING INSTRUCTIONS
3
4
While keeping the secondary lock button depressed,
lift the handle up and forward to fold the stroller
down.
Ensure folding lock is engaged.
3a.
4a.
To fold Stroller continued...

14
HOW TO CARE FOR YOUR CHILDCARE STROLLER
Cleaning
Maintenance
To ensure the long-lasting use of your stroller,dry it with a soft absorbent
cloth after use in rainy weather.Use a damp cloth to clean the frame.
Do not use abrasive cleaners.After using your stroller on the beach,
clean the frame and wheels thoroughly with water to remove the sand
and salt. Allow it to dry thoroughly. Removable and non-removable
fabric covers and trims may be cleaned using a damp cloth with
soap or mild detergent. Allow it to dry completely before folding or
storing away. Do not dry clean or use bleach on fabrics or trims. Do
not machine wash, tumble or spin dry, unless the care labelling on
the product permits these methods.
Check stroller regularly to ensure that locking devices and
components are secure and working properly. Always check parts
regularly for tightness of screws, nuts and other fasteners – tighten or
replace if required.To maintain the safety of your stroller,seek prompt
repairs for bent, torn, worn or broken parts. Use only those parts and
accessories approved by CNP Brands. If the wheels squeak, use
silicone based spray or light oil ensuring it penetrates the wheel and
axle assembly. To prevent mould or mildew, do not fold or store the
product if it is damp or wet.Allow it to dry thoroughly.Always store the
product in a well ventilated area and away from direct sunlight.
If you have any difculties in assembling the stroller, please contact
our Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand
contact Wainhouse Distribution on 0800 567 5000.

15
ABOUT US
About CNP Brands
Currently,CNP Brands boasts one of the most diverse brand portfolios
with a combination of company owned brands and distribution
agreements. These include distribution lines for 4moms, Cybex,
Eveno,Good Baby, Lascal, Maclaren, Motorola,OiOi and Summer
Infant.
Our own brands, including Childcare, have gone from strength to
strength in recent years. Childcare, and our premium brand bebe
care, demonstrate our commitment to quality and continuing
investment in product development.

16
Distributed in Australia by CNP Brands
20 Calarco Drive,
Derrimut,VIC, 3030
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: [e-mail]
F: www.facebook.com/CNPBrands
I: @cnp_baby
Distributed in New Zealand by Wainhouse
Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes,Auckland, New Zealand
Customer Service: 0800 567 5000
E: [email protected].nz