Cleveland 24-CGA-6 User manual

Cleveland Range LLC.
1333 East 179th St., Cleveland, Ohio, U.S.A. 44110
Ph:1-216-481-4900 Fx:1-216-481-3782
Visit our Web Site at www.clevelandrange.com
MODEL: 24-CGA-6
ITEM NUMBER __________________________________________
JOB NAME / NUMBER __________________________________
Cleveland Standard Features
■Each Compartment has cooking capacity for 3 each
12˝ x 20˝ x 21⁄2˝ Steam Table Pans
■Two compartments for convection steam cooking and one
compartment for storage.Doors hinged left and the controls
on the right
■75% efficient independent Power Burner Steam Generators
35,000 BTUs each
■Each steam-cooking compartment is independently operated
and controlled by a separate stainless steel steam generator,
gas valve, Power On/Off Control Levers and a Exclusive,
Remote Probe-Type Water Level Control
■Easy Access Cleaning Port: Each generator has a deliming
port located on the outside, top of the unit
■Generator Cleaning Light for each compartment warns the
operator to delime generator
■Instant Steam Standby Mode:Holds generator at a steaming
temperature, allows unit to start cooking instantly
■Each compartment has one, 60-Minute MechanicalTimer and
a Manual Bypass Switch for constant steaming
■Durable 14 Gauge, 304 Stainless Steel construction for
compartment door, cooking cavity and steam generator
■Exclusive Gemini Drain/Power Control System:
Manual 1/2 inch "Ball Valve" type drain that controls main
power On/Off, and automatically fills generator
■Exclusive Brass Steam Jets distribute steam even throughout
cooking compartment
■Easy, Front -Access Generator Controls comes with a pullout
drawer for simple servicing of unit
■6˝ Stainless Steel Adjustable Legs with Flanged Feet
■Approvals: AGA, NSF
■Compartment Steam Shut-Off Switch (SCS)
Options & Accessories
❐Electronic Timer with Compensating Feature (ETC)
❐On/Off Steam Switch Controls, no timer (MC)
❐Propane Gas (PG)
❐Dissolve®Descale Solution, 6 one gallon container w/quart
markings (106174)
❐Water Filters
Cleveland SteamCraft

GeminiTM Model 24CGA6, Two compart-
ment steamer, one compartment storage. Independent steam
generator, gas valve and water level control system. Exclusive
remote probe-type water level controls. Exclusive Brass “Steam
Jet” distribution system. Two-piece free-floating compartment
door. 14 gauge stainless steel cavity and door. Pullout service
drawer for controls and Gemini Drain/Power Control System.
Short Form Specifications
SECT. IV PAGE 11
0402
SteamCraft ®Gemini TM 6
PRESSURELESS STEAMER
TWIN, INDEPENDENT GAS-FIRED GENERATORS

GAS ELECTRIC COLDWATER CLEARANCE DRAINAGE
1
1
⁄ 4 ˝ IPS line size,
3
⁄ 4 ˝ (13mm) connection 120V-1Phase, 60 Hz. 35 psi minimum RIGHT = 12.00˝ 1
1
⁄ 2 ˝ dia.
NATURAL PROPANE BTU 2 Blowers & Controls 60 psi maximum LEFT = 3.00˝ Do not connect other
Piping
3
⁄ 4 ˝ N.P.T. Piping
3
⁄ 4 ˝ N.P.T. 35,000 each 150 watts each C2
3
⁄ 8 ˝ dia. NPT for Generator REAR = 3.00˝ units to this drain
Supply pressure Supply pressure Generator, C1
3
⁄ 8 ˝ dia. NPT for Condenser Allow 6˝ space min.
4.50˝ W.C. Min. 11.00˝ W.C.Min. 70,000 total from rear and sides Drain must be vented
14.00˝ W.C. Max. 14.00˝ W.C. Max. When located near
combustible walls Do not use PVC pipe
Manufacturer must be notified if unit will
be used above 2,000 feet
(NOT TO SCALE)
SECT. IVPAGE 12
0402
Litho in U.S.A.
Each Compartment has Capacity for:
• Three 21⁄2˝ x 12˝ x 20˝ Steam Table Pans
• Six 1˝ x 12˝ x 20˝ Steam Table Pans
• Two 4˝ x 12˝ x 20˝ Steam Table Pans
C
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are UL/NSF#4 and CSA (AGA, CGA).
D
WATER QUALITY
REQUIREMENTS
The quality of water varies
greatly from region to
region. Steam equipment
generators must be
drained daily and chemi-
cally descaled periodically
to ensure proper operation.
To minimize service prob-
lems caused by the accu-
mulation of minerals and
chemicals in water review
the following quality guide-
lines with a local water
treatment specialist. Inlet
water that is beyond these
specified guidelines should
be treated to achieve these
acceptable limits. Total
Dissolved Solids less than
60 ppm, Alkalinity less than
20 ppm, Silica less than 13
ppm, pH factor greater
than 7.5, Chlorine less
than 30 ppm.
Right - 3”, Left - 3”,
Rear -3”
(12” on control side if
adjoining wall or
equipment is over 30”
high for service access)
Contact factory
for variances to
clearances.